Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the computer in the car is getting a signal that says the brake pedal sensor is receiving too much electricity.
The brake pedal position sensor monitors the position of the brake pedal and sends this information to the vehicle's control systems. If the supply voltage to this sensor is too high, it can cause incorrect readings.
The C10B6 code is triggered when the vehicle's control module detects a voltage level that is higher than the expected range in the brake pedal position sensor's supply voltage circuit. This may affect the vehicle's braking system performance.
• Brake warning light on the dashboard
• Unresponsive or erratic brake pedal behavior
• Possible reduction in braking performance
• Faulty brake pedal position sensor
• Wiring issues such as shorts or open circuits
• Malfunctioning control module
OBD-II: On-Board Diagnostics, a standardized system in vehicles for monitoring performance.
Sensor: A device that detects or measures a physical property and records, indicates, or otherwise responds to it.
• Use an OBD-II scanner to confirm the code
• Visually inspect the brake pedal position sensor and its wiring
• Check the voltage levels at the sensor using a multimeter
• Replace the brake pedal position sensor if faulty
• Repair or replace damaged wiring or connectors
• Reprogram or replace the control module if necessary
• OBD-II scanner
• Multimeter
• Basic hand tools (screwdrivers, pliers)
$100 - $300
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regularly inspect brake system components
• Ensure proper maintenance of electrical systems
• Address warning lights promptly
Sensor Issue
• Do not ignore the brake warning light
• Have the vehicle inspected by a professional
• Avoid driving the vehicle if braking performance is compromised
Check with your vehicle manufacturer as some components may be covered under warranty.
This code has been reported in various models with electronic brake systems, often due to sensor or wiring issues.
High – Brake system issues should be addressed immediately to ensure vehicle safety.
Driving with a compromised braking system can be dangerous and may violate vehicle safety regulations.
• Vehicle must be stationary
• Ignition in the 'ON' position
The brake pedal position sensor is typically located near the brake pedal assembly inside the vehicle cabin.
Q: Can I drive with the C10B6 code?
A: It's not recommended to drive with this code active, as it may affect braking performance.
Q: How can I reset the C10B6 code?
A: After repairs, use an OBD-II scanner to clear the code. If the issue persists, further diagnosis is needed.
Pro · Four-system diagnostics
A handheld scanner aimed at engine, transmission, ABS, and airbag diagnostic work.
Chassis and ABS faults usually need a scanner that can read brake-system data directly.
View on Amazon
Universal · Torque wrench
Useful when reassembly torque matters for wheel, suspension, and under-hood fasteners.
Useful when wheel, hub, or suspension hardware needs correct reassembly torque.
View on Amazon
Universal · Drive-on ramps
Helpful for safer access underneath the vehicle during exhaust, EVAP, and underbody inspection work.
Helpful for safer access during underbody inspection work.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.