Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means there's a problem with the electric motor in your car. It's like when a toy's motor isn't working right because it's not getting enough power.
The P2C6C code indicates an issue with the current flowing through the Y phase of Drive Motor 'A'.
The P2C6C code is triggered when the vehicle's control module detects an irregularity in the current of Phase Y of the drive motor 'A'. This could be due to an electrical fault or a problem with the motor itself.
• Reduced vehicle performance
• Warning light on the dashboard
• Unusual noises from the motor
• Faulty drive motor
• Damaged wiring or connectors
• Defective control module
Drive Motor: An electric motor that powers the vehicle.
Phase Y: One of the phases in a three-phase electric motor system.
• Check for any other related codes.
• Inspect the wiring and connectors for damage.
• Test the drive motor for proper operation.
• Repair or replace damaged wiring.
• Replace the faulty drive motor.
• Reprogram or replace the control module if necessary.
• OBD-II scanner
• Multimeter
• Wiring diagram
$500 - $1500
Difficult
• Chevrolet Bolt
• Nissan Leaf
• Tesla Model 3
• Regular maintenance checks
• Avoid overloading the vehicle
• Ensure proper charging practices
Electric Motor Performance
• Do not ignore the warning light.
• Seek professional diagnosis and repair.
• Avoid driving the vehicle if performance is severely affected.
Check with your vehicle manufacturer for warranty coverage on electric motor components.
This code has become more common as electric vehicles have increased in popularity.
High – Immediate attention is needed to prevent further damage.
Driving with this code may lead to reduced performance and potential safety risks.
• Vehicle at operating temperature
• Under normal driving conditions
The drive motor is typically located near the vehicle's axle or transmission.
Q: Can I drive with a P2C6C code?
A: It's not recommended to drive with this code as it may lead to further damage.
Q: How do I reset the P2C6C code?
A: After repairs, use an OBD-II scanner to clear the code. If the issue persists, the code will return.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.