Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the computer in the car found that the electric motor is using too much power on one of its wires.
The vehicle's control module has detected that the current in the Phase Y of Drive Motor 'A' is higher than expected.
P2C6E is a diagnostic trouble code indicating that the current in the Phase Y of the Drive Motor 'A' is above the threshold set by the manufacturer. This can be due to an electrical fault, such as a short circuit or a malfunctioning motor controller.
• Reduced vehicle performance
• Warning light on the dashboard
• Unusual noises from the motor
• Short circuit in the drive motor wiring
• Faulty drive motor controller
• Internal failure in the drive motor
Drive Motor: The electric motor that powers the vehicle.
Phase Y: One of the phases in a three-phase electric motor system.
• Check for any related trouble codes
• Inspect the wiring and connectors for damage
• Test the drive motor and controller for proper operation
• Repair or replace damaged wiring
• Replace the drive motor controller if faulty
• Replace the drive motor if necessary
• OBD-II scanner
• Multimeter
• Insulation resistance tester
$500 - $2000
Difficult
• Chevrolet Volt
• Nissan Leaf
• Toyota Prius
• Regular maintenance checks
• Avoiding overloading the vehicle
• Ensuring proper cooling of the motor
Electric Motor Performance
• Avoid driving the vehicle until repaired
• Consult with a professional mechanic
• Do not attempt DIY repairs unless qualified
Check the vehicle's warranty for coverage on electric motor components.
This code has become more common with the increased use of electric and hybrid vehicles.
High – This issue can lead to further damage if not addressed promptly.
Driving with this fault may not comply with emission standards and could be unsafe.
• Vehicle at operating temperature
• Under load conditions
The drive motor is typically located near the vehicle's axle or under the hood, depending on the design.
Q: Can I drive with a P2C6E code?
A: It's not recommended to drive with this code active as it can lead to further damage.
Q: What happens if I ignore the P2C6E code?
A: Ignoring this code can result in reduced vehicle performance and potential motor damage.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.