Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the computer in your car has detected that the electric motor is using too much power in a specific part of its operation. It's like when you plug too many things into an outlet and it gets overloaded.
The vehicle's control module monitors the current flow through the drive motor's phases. If it detects a current level that is higher than expected, it triggers this code.
P2C6B indicates that the drive motor 'A' is experiencing a high current condition in phase X. This could be due to an electrical fault, such as a short circuit or a failure in the motor control system.
• Reduced vehicle performance
• Warning light on the dashboard
• Unusual noises from the motor
• Short circuit in the motor windings
• Faulty motor control module
• Damaged wiring harness
Drive Motor: An electric motor that powers the vehicle's wheels.
Phase: A stage in the electrical cycle of a motor.
• Perform a diagnostic scan to confirm the code.
• Inspect the wiring and connectors for damage.
• Test the motor control module for faults.
• Repair or replace damaged wiring.
• Replace the faulty motor control module.
• Inspect and repair the motor windings.
• OBD-II scanner
• Multimeter
• Insulation resistance tester
$300 - $1500
Difficult
• Chevrolet Volt
• Nissan Leaf
• Toyota Prius
• Regular maintenance checks
• Avoid overloading the vehicle
• Ensure proper cooling of the motor
Electric Motor Performance
• Take the vehicle to a professional for diagnosis.
• Avoid driving the vehicle until repaired to prevent further damage.
Check with the manufacturer for warranty coverage on electric motor components.
This code is more common in electric and hybrid vehicles due to their reliance on electric drive motors.
High – Immediate attention is required to prevent further damage.
Driving with this issue can lead to a breakdown or further damage to the vehicle's electric system.
• Vehicle stationary
• Engine off
The drive motor is typically located near the front or rear axle, depending on the vehicle's design.
Q: Can I drive my car with a P2C6B code?
A: It's not recommended to drive with this code active as it can cause further damage.
Q: What does 'Phase X' mean?
A: Phase X refers to one of the electrical phases in the motor's operation, similar to how household electricity has phases.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.