Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer noticed a problem with the signals from the parts that tell how much you're pressing the gas pedal. It's like when two friends tell you different stories about the same event, and you get confused.
The engine control module (ECM) has detected a discrepancy between the voltage signals from the throttle position sensor A and the pedal position sensor G.
The P2AD3 code indicates that the ECM has found a voltage correlation issue between the throttle position sensor A and the pedal position sensor G. These sensors are responsible for communicating the position of the throttle and pedal to the ECM. If the signals from these sensors do not match the expected values, the ECM triggers this code.
• Check Engine Light illuminated
• Poor acceleration
• Unstable idle
• Faulty throttle position sensor
• Faulty pedal position sensor
• Wiring issues or poor connections
ECM: Engine Control Module
OBD-II: On-Board Diagnostics II
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connectors for damage or corrosion.
• Test the throttle and pedal position sensors for proper operation.
• Replace the faulty throttle position sensor.
• Replace the faulty pedal position sensor.
• Repair or replace damaged wiring or connectors.
• OBD-II scanner
• Multimeter
• Screwdriver set
$100 - $300
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regularly inspect and maintain sensor connections.
• Avoid exposure to moisture and contaminants.
• Perform periodic sensor calibration checks.
Sensor Issue
• Do not ignore the Check Engine Light.
• Get the vehicle diagnosed as soon as possible.
• Avoid driving if the vehicle exhibits poor performance.
Check with the vehicle manufacturer for warranty coverage on sensors.
This code has been reported in vehicles with electronic throttle control systems, especially in models with high mileage.
Moderate – Address the issue soon to avoid further complications.
Driving with a malfunctioning throttle or pedal position sensor can lead to unsafe driving conditions.
• Engine running
• Vehicle stationary
The throttle position sensor is located on the throttle body, and the pedal position sensor is attached to the accelerator pedal assembly.
Q: Can I drive with a P2AD3 code?
A: It's not recommended, as it can lead to poor vehicle performance and unsafe driving conditions.
Q: How do I clear a P2AD3 code?
A: After repairing the issue, use an OBD-II scanner to clear the code. If the problem persists, the code will return.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.