Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means the car's computer isn't getting any information from a sensor that tells it how fast a part inside the transmission is spinning.
The P2767 code is triggered when the Powertrain Control Module (PCM) detects no signal from the Input/Turbine Shaft Speed Sensor B.
The Input/Turbine Shaft Speed Sensor B is responsible for monitoring the rotational speed of the input shaft in the transmission. This data is crucial for the PCM to manage transmission shifting and engine load. A 'No Signal' condition means the sensor is not sending any data, which could be due to electrical issues or sensor failure.
• Check Engine Light is on
• Transmission may not shift properly
• Poor fuel economy
• Faulty Input/Turbine Shaft Speed Sensor B
• Damaged wiring or connectors in the sensor circuit
• PCM issues
PCM: Powertrain Control Module
OBD-II: On-Board Diagnostics II
• Use an OBD-II scanner to verify the code.
• Inspect the wiring and connectors for damage.
• Test the Input/Turbine Shaft Speed Sensor B for proper operation.
• Replace the Input/Turbine Shaft Speed Sensor B if faulty.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the PCM if necessary.
• OBD-II Scanner
• Multimeter
• Basic hand tools
$150 - $400
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regularly inspect and maintain transmission components.
• Ensure all electrical connections are secure.
• Use quality replacement parts.
Sensor Issue
• Avoid driving at high speeds until the issue is resolved.
• Consult a professional mechanic for accurate diagnosis.
Check your vehicle's warranty for coverage on transmission components.
This code has been associated with transmission issues in vehicles with automatic transmissions, particularly those with higher mileage.
Moderate – It is advisable to address this issue soon to avoid potential transmission damage.
Driving with a malfunctioning transmission sensor can lead to unsafe driving conditions.
• Vehicle at operating temperature
• Transmission in drive
The Input/Turbine Shaft Speed Sensor B is typically located on the transmission housing.
Q: Can I drive with a P2767 code?
A: It's not recommended to drive for long periods with this code as it can lead to transmission issues.
Q: How do I reset the P2767 code?
A: After repairs, use an OBD-II scanner to clear the code. If the issue is fixed, it should not return.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.