Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means there's a problem with the sensor that tells the car how much you're pressing the gas pedal. It's not getting enough power, so the car might not know how fast you want to go.
The P11EE code indicates that the voltage in the circuit for the throttle/pedal position sensor 'E' is lower than expected.
The throttle/pedal position sensor/switch 'E' is responsible for sending signals to the engine control module (ECM) about the position of the throttle or pedal. A 'voltage low' condition means the ECM is receiving a voltage signal that is below the specified range, which could be due to a fault in the sensor, wiring, or connector.
• Check Engine Light is on
• Poor acceleration
• Engine may not respond properly to throttle input
• Faulty throttle/pedal position sensor
• Damaged wiring or connectors
• Faulty ECM
ECM: Engine Control Module
Throttle Body: The part of the air intake system that controls the amount of air flowing into the engine
• Use an OBD-II scanner to confirm the P11EE code.
• Inspect the throttle/pedal position sensor and its wiring for damage.
• Test the voltage and ground signals at the sensor.
• Replace the throttle/pedal position sensor if faulty.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the ECM if necessary.
• OBD-II scanner
• Multimeter
• Screwdriver set
$150 - $400
Moderate
• Chevrolet Silverado
• Ford F-150
• Toyota Camry
• Regularly inspect and maintain the throttle system.
• Ensure connectors are clean and secure.
• Avoid harsh driving conditions that may damage sensors.
Sensor Issue
• Avoid heavy acceleration until the issue is resolved.
• Consult a professional mechanic for diagnosis.
Check with your vehicle manufacturer for specific warranty coverage on sensors.
This code has been associated with throttle position sensor issues in various models, often due to wear and tear or electrical issues.
Moderate – It affects vehicle performance but is not immediately dangerous.
Driving with a malfunctioning throttle sensor can lead to reduced vehicle performance and may be unsafe.
• Engine running
• Throttle pedal pressed
The throttle/pedal position sensor is typically located near the throttle body or on the accelerator pedal assembly.
Q: Can I drive with a P11EE code?
A: It's possible to drive, but it's not recommended as it can affect vehicle performance and safety.
Q: How do I reset the Check Engine Light after fixing the issue?
A: Use an OBD-II scanner to clear the code or disconnect the battery for a few minutes.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.
Fitment Required · Vehicle-fitment part
Relevant for airflow, fuel-trim, and intake-metering faults after confirming the sensor is actually at fault.
Airflow and fuel-trim codes can involve the mass air flow sensor after proper diagnosis.
Verify the sensor design and fitment for your exact vehicle.
View options on AmazonThese parts may be related to this fault category, but a code by itself does not confirm exact fitment or guarantee that replacing a part will solve the problem.