Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer is getting a signal that is too high from a sensor that helps control how much gas the engine gets when you press the pedal.
The P11CF code indicates that the voltage from the throttle or pedal position sensor 'D' is higher than expected, which can affect the engine's performance.
P11CF is triggered when the Engine Control Module (ECM) detects a voltage signal from the throttle/pedal position sensor/switch 'D' that is higher than the specified range. This sensor helps the ECM determine the position of the throttle or pedal to regulate engine power and fuel delivery.
• Check Engine Light is on
• Poor acceleration
• Engine may run rough or stall
• Faulty throttle/pedal position sensor
• Wiring issues such as shorts or open circuits
• Faulty ECM or PCM
ECM: Engine Control Module
PCM: Powertrain Control Module
OBD-II: On-Board Diagnostics II
• Use an OBD-II scanner to confirm the code
• Inspect the wiring and connectors for damage
• Test the throttle/pedal position sensor with a multimeter
• Replace the throttle/pedal position sensor
• Repair or replace damaged wiring or connectors
• Reprogram or replace the ECM if necessary
• OBD-II scanner
• Multimeter
• Screwdriver set
$100 - $300
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regularly inspect and maintain the throttle body and sensors
• Keep the engine bay clean to prevent dirt buildup
• Ensure all electrical connections are secure
Sensor Issue
• Avoid driving aggressively until the issue is fixed
• Have the vehicle inspected by a professional mechanic
Check your vehicle's warranty coverage for powertrain components.
This code has been more common in vehicles with electronic throttle control systems.
Moderate – While the vehicle may still be drivable, it could lead to further engine performance issues if not addressed.
Driving with a malfunctioning throttle sensor can lead to unsafe driving conditions. Repair the issue promptly.
• Engine running
• Vehicle stationary
The throttle/pedal position sensor is typically located on the throttle body or near the accelerator pedal.
Q: Can I drive with a P11CF code?
A: It's not recommended as it can lead to poor engine performance and unsafe driving conditions.
Q: How do I reset the P11CF code?
A: After repairs, use an OBD-II scanner to clear the code from the ECM.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.