Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer thinks the air pressure outside is too low, like when you're high up in the mountains.
The car's computer monitors the barometric pressure to adjust engine performance. If it reads too low, it may trigger this code.
The P113E code is set when the Powertrain Control Module (PCM) detects that the barometric pressure sensor 'B' is reading a value that is lower than expected. This sensor helps the PCM adjust the air-fuel mixture and ignition timing based on the altitude and atmospheric pressure.
• Check Engine Light is on
• Poor engine performance
• Increased fuel consumption
• Faulty barometric pressure sensor
• Wiring issues or poor connection
• Faulty PCM
PCM: Powertrain Control Module
OBD-II: On-Board Diagnostics II
• Use an OBD-II scanner to confirm the code.
• Inspect the barometric pressure sensor and its wiring.
• Test the sensor's voltage and resistance.
• Replace the barometric pressure sensor if faulty.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the PCM if necessary.
• OBD-II scanner
• Multimeter
• Screwdriver set
$100 - $300
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regularly inspect and maintain sensors.
• Keep electrical connections clean and secure.
• Ensure proper vehicle maintenance.
Sensor Issue
• Have the vehicle inspected by a professional.
• Avoid driving in extreme altitudes if possible.
• Monitor fuel consumption for any unusual changes.
Check with your vehicle manufacturer for warranty coverage on sensors.
This code has been associated with vehicles operating in high altitude areas or with faulty sensors.
Moderate – It should be addressed soon to avoid potential engine performance issues.
Driving with a faulty sensor may lead to increased emissions, which can be illegal in some areas.
• Vehicle at operating temperature
• Engine running at idle
The barometric pressure sensor is typically located on the intake manifold or near the air filter housing.
Q: Can I drive with a P113E code?
A: It's possible, but not recommended as it can affect engine performance and fuel efficiency.
Q: How do I reset the P113E code?
A: Fix the underlying issue first, then use an OBD-II scanner to clear the code.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.
Fitment Required · Vehicle-fitment part
Commonly relevant for misfire, ignition-efficiency, and some drivability-related repairs.
Misfire and ignition-related faults commonly involve spark plugs as part of the repair path.
Check the correct plug type, gap, and engine application for your vehicle.
View options on Amazon
Fitment Required · Vehicle-fitment part
Relevant when the fault points toward ignition-coil performance or cylinder-specific ignition issues.
Some ignition faults involve coil performance or cylinder-specific coil problems.
Match the coil to your engine and confirm the failed component before ordering.
View options on AmazonThese parts may be related to this fault category, but a code by itself does not confirm exact fitment or guarantee that replacing a part will solve the problem.