Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the sensor which checks the temperature of the air going into the engine is reading too high. It's like a thermometer that is saying it's hotter than it should be.
The P007D code indicates that the charge air cooler temperature sensor is reporting a higher temperature than expected. This sensor helps monitor the temperature of the air after it has been cooled by the charge air cooler.
The charge air cooler temperature sensor measures the temperature of the air after it has passed through the charge air cooler. This sensor sends data to the engine control module (ECM) to ensure optimal air temperature for combustion. A 'high' circuit code suggests that the sensor is sending a voltage signal that is higher than the ECM's expected range, indicating a possible fault in the sensor or its circuit.
• Check Engine Light is on
• Poor engine performance
• Reduced fuel efficiency
• Faulty charge air cooler temperature sensor
• Wiring issues such as short circuits or open circuits
• Faulty ECM
Charge Air Cooler: A device that cools the air compressed by the turbocharger before it enters the engine.
ECM: Engine Control Module, the computer that manages engine functions.
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connections to the charge air cooler temperature sensor.
• Test the sensor's resistance and voltage output.
• Replace the charge air cooler temperature sensor.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the ECM if necessary.
• OBD-II scanner
• Digital multimeter
• Basic hand tools
$100 - $300
Moderate
• Ford F-150
• Chevrolet Silverado
• Dodge Ram
• Regular maintenance checks
• Ensure proper sensor installation
• Avoid exposure of wiring to extreme conditions
Sensor Issue
• Have the vehicle inspected by a professional.
• Avoid driving the vehicle hard until the issue is resolved.
Check with your vehicle manufacturer for warranty coverage on sensors and related components.
This code is relatively common in turbocharged engines where charge air coolers are used to lower the temperature of the intake air.
Moderate – It should be addressed soon to prevent further engine performance issues.
Driving with a faulty sensor can lead to increased emissions and reduced fuel efficiency.
• Engine at operating temperature
• Vehicle in a safe, stationary position
The charge air cooler temperature sensor is typically located near the charge air cooler, which is part of the intake system in turbocharged engines.
Q: Can I drive with a P007D code?
A: It's possible, but not recommended for long periods as it may affect engine performance and fuel efficiency.
Q: How do I reset the Check Engine Light after fixing the issue?
A: You can use an OBD-II scanner to clear the code, or disconnect the battery for a few minutes to reset the ECM.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.