Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that a sensor that measures how hot a part of the engine is (the camshaft position actuator) is saying the temperature is too high on one side of the engine.
The engine control module (ECM) has detected a high voltage signal from the camshaft position actuator temperature sensor on bank 2, indicating a high temperature reading.
The P34BB code is triggered when the ECM receives a signal from the camshaft position actuator temperature sensor that is higher than the expected range. This sensor monitors the temperature of the camshaft position actuator, which adjusts the timing of the camshaft for optimal engine performance. Bank 2 refers to the side of the engine opposite to bank 1, typically the side not containing cylinder 1.
• Check Engine Light is on
• Poor engine performance
• Increased fuel consumption
• Faulty camshaft position actuator temperature sensor
• Wiring issues such as shorts or open circuits
• Faulty ECM
ECM: Engine Control Module
Camshaft: A shaft in the engine that controls the opening and closing of the intake and exhaust valves.
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connectors related to the sensor.
• Test the camshaft position actuator temperature sensor for proper operation.
• Replace the camshaft position actuator temperature sensor.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the ECM if necessary.
• OBD-II scanner
• Multimeter
• Wrench set
$150 - $400
Moderate
• Chevrolet Silverado
• GMC Sierra
• Cadillac Escalade
• Regularly check and maintain engine sensors.
• Inspect wiring and connections for damage.
• Ensure proper engine cooling system function.
Sensor Issue
• Do not ignore the Check Engine Light.
• Have the vehicle inspected by a professional mechanic.
• Avoid driving aggressively until the issue is resolved.
Check with your vehicle manufacturer for specific warranty coverage related to engine sensors.
This code has been associated with vehicles that have experienced wiring issues or sensor failures in the past.
Moderate – It is recommended to address this issue soon to avoid potential engine performance problems.
Driving with a malfunctioning engine sensor can lead to decreased performance and increased emissions, which may not comply with local regulations.
• Engine at operating temperature
• Vehicle in a safe, stationary position
The camshaft position actuator temperature sensor is located near the camshaft position actuator on bank 2 of the engine.
Q: What does bank 2 mean?
A: Bank 2 refers to the side of the engine opposite to bank 1, which typically contains cylinder 1.
Q: Can I drive with this code?
A: It's best to have the issue checked by a mechanic as soon as possible to avoid potential engine damage.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.