Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer has detected a problem with the sensor that measures how much electricity is going to one part of the electric motor. It's like a thermometer that is showing a temperature that's too high.
The vehicle's control module has detected that the current sensor for the drive motor's phase X is reading higher than expected.
The P2E1E code indicates an issue with the current sensor circuit for the drive motor's phase X. This may involve a malfunction in the sensor, wiring, or connections that cause the sensor to report a higher than normal current reading.
• Reduced vehicle performance
• Warning light on the dashboard
• Possible failure to start the vehicle
• Faulty current sensor
• Wiring issues such as shorts or open circuits
• Defective drive motor control module
Current Sensor: A device that measures the amount of electrical current flowing through a circuit.
Drive Motor: The electric motor that propels the vehicle.
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connections to the current sensor.
• Test the current sensor for proper operation.
• Replace the faulty current sensor.
• Repair or replace damaged wiring or connectors.
• Replace the drive motor control module if necessary.
• OBD-II scanner
• Multimeter
• Basic hand tools
$200 - $800
Moderate
• Chevrolet Volt
• Nissan Leaf
• Toyota Prius
• Regular maintenance checks
• Ensure wiring is secure and undamaged
• Avoid excessive moisture exposure
Sensor Issue
• Have the vehicle inspected by a professional.
• Avoid driving the vehicle until the issue is resolved.
Check with the vehicle manufacturer for warranty coverage on hybrid or electric system components.
This code has been more prevalent with the increase of hybrid and electric vehicles, highlighting the importance of sensor accuracy in these systems.
Moderate – It should be addressed soon to prevent further issues or reduced vehicle performance.
Driving with this code may lead to reduced performance or safety issues. Address promptly.
• Vehicle in 'ON' position
• Drive motor engaged
The current sensor is typically located near the drive motor or integrated into the motor control module.
Q: Can I drive with a P2E1E code?
A: It's not recommended to drive with this code as it may affect vehicle performance and safety.
Q: How do I reset the P2E1E code?
A: After repairs, the code can be cleared using an OBD-II scanner.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.