Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer is not getting the right signal from the sensor that tells it what position the gear lever is in. It's like when a light switch is broken and doesn't tell the light to turn on or off.
The P2E0E code indicates that the voltage signal from the gear lever position sensor D is lower than the expected range.
The gear lever position sensor is responsible for sending the current position of the gear lever to the vehicle's computer. When the circuit is low, it means the voltage reading from the sensor is below the manufacturer's specified range, indicating a possible issue with the sensor or its wiring.
• Check Engine Light is on
• Transmission may not shift properly
• Vehicle may not start
• Faulty gear lever position sensor
• Damaged or corroded wiring or connectors
• Faulty transmission control module (TCM)
OBD-II: On-Board Diagnostics, a system that monitors vehicle performance and reports issues.
TCM: Transmission Control Module, a device that controls the transmission functions.
• Use an OBD-II scanner to confirm the code
• Inspect the wiring and connectors for damage or corrosion
• Test the gear lever position sensor for proper operation
• Replace the gear lever position sensor
• Repair or replace damaged wiring or connectors
• Reprogram or replace the transmission control module
• OBD-II scanner
• Multimeter
• Screwdriver set
$150 - $400
Moderate
• Ford Focus
• Chevrolet Malibu
• Toyota Camry
• Regularly inspect and maintain vehicle wiring
• Avoid exposure of electrical components to moisture
• Perform routine diagnostic checks
Sensor Issue
• Do not ignore the Check Engine Light
• Seek professional diagnostic services if unsure
• Regularly maintain your vehicle to prevent such issues
Check with your vehicle manufacturer for specific warranty coverage on sensors and electrical components.
This code has been associated with vehicles that have experienced issues with their gear position sensors due to wear or exposure to harsh conditions.
Moderate – While the vehicle may still operate, improper gear indication can lead to further transmission issues.
Driving with a faulty gear position sensor can lead to unsafe driving conditions. Address this issue promptly.
• Vehicle in park with ignition on
• Use of diagnostic tools to monitor sensor voltage
The gear lever position sensor is typically located on or near the transmission housing.
Q: Can I drive with a P2E0E code?
A: It's not recommended as it may lead to unsafe driving conditions or further transmission damage.
Q: How can I reset the P2E0E code?
A: After addressing the issue, use an OBD-II scanner to clear the code from the vehicle's computer.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.