Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer has detected a problem with the electrical circuit that can turn off the hybrid or electric vehicle's battery. It's like a switch that isn't working right.
The P2C98 code is triggered when the vehicle's control module detects a high voltage condition in the hybrid or EV battery disable circuit.
The P2C98 code indicates that the voltage in the hybrid or electric vehicle's battery disable circuit is higher than the expected range. This circuit is responsible for safely disconnecting the battery when needed, and a high voltage reading can suggest a fault in the wiring, connectors, or control module.
• Check Engine Light is on
• Reduced vehicle performance
• Inability to disable the battery safely
• Faulty battery disable relay
• Damaged wiring or connectors in the disable circuit
• Malfunctioning control module
Hybrid: A vehicle that uses both an internal combustion engine and electric power.
EV: Electric Vehicle, a car that runs solely on electric power.
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connectors in the battery disable circuit for damage.
• Test the battery disable relay for proper operation.
• Replace faulty battery disable relay.
• Repair or replace damaged wiring/connectors.
• Reprogram or replace the control module if necessary.
• OBD-II scanner
• Multimeter
• Basic hand tools
$150 - $500
Moderate
• Toyota Prius
• Chevrolet Volt
• Nissan Leaf
• Regularly inspect electrical connections.
• Ensure proper maintenance of hybrid/EV systems.
• Avoid exposing the vehicle to extreme conditions that can damage wiring.
Electrical Circuit Issue
• Do not attempt to drive the vehicle until the issue is resolved.
• Consult a professional mechanic experienced with hybrid/EV systems.
Check with the vehicle manufacturer for warranty coverage on hybrid/EV components.
This code has been associated with issues in early hybrid and EV models as they age, particularly with wear and tear on electrical components.
High – This issue can affect the safety and performance of the vehicle.
Operating a vehicle with a malfunctioning battery disable circuit can be unsafe. It is advised to address the issue promptly.
• Vehicle in 'ON' position
• Battery system fully charged
The battery disable circuit components are typically located near the hybrid/EV battery pack, often in the rear of the vehicle.
Q: Can I drive my car with the P2C98 code?
A: It's not recommended to drive the vehicle until the issue is fixed, as it may pose safety risks.
Q: Is this a common issue?
A: This code is relatively uncommon but can occur in aging hybrid/EV vehicles.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.