Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer is having trouble with the part that helps the car change gears. It's like when a video game controller button doesn't work right.
The P2776 code indicates a problem with the electrical circuit that controls the upshift switch in the vehicle's transmission system.
The P2776 code is triggered when the Powertrain Control Module (PCM) detects a low voltage or open circuit condition in the upshift switch circuit. This switch is part of the transmission control system and is responsible for signaling the transmission to shift to a higher gear.
• Check Engine Light is on
• Transmission may not shift properly
• Reduced fuel efficiency
• Faulty upshift switch
• Damaged wiring or connectors
• Faulty PCM
PCM: Powertrain Control Module
OBD-II: On-Board Diagnostics, Second Generation
• Use an OBD-II scanner to confirm the code.
• Inspect the upshift switch and its wiring for damage.
• Test the voltage and continuity of the upshift switch circuit.
• Replace the faulty upshift switch.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the PCM if necessary.
• OBD-II scanner
• Multimeter
• Screwdriver set
$100 - $300
Moderate
• Toyota Camry
• Honda Accord
• Ford F-150
• Regular maintenance of transmission system
• Periodic inspection of wiring and connectors
• Timely repair of any transmission issues
Transmission Control System Issue
• Avoid driving the vehicle extensively until fixed.
• Consult a professional mechanic for diagnosis and repair.
Check with your vehicle manufacturer for warranty coverage on transmission components.
This code has been associated with vehicles that have electronic transmission controls, especially in models from the early 2000s.
Moderate – It should be addressed soon to prevent further transmission issues.
Driving with transmission issues can be unsafe and may lead to further damage.
• Vehicle at operating temperature
• Transmission in drive mode
The upshift switch is typically located on the transmission or gear selector assembly.
Q: Can I drive with a P2776 code?
A: It's possible to drive, but it's not recommended as it may cause further damage to the transmission.
Q: How can I reset the P2776 code?
A: After fixing the issue, you can use an OBD-II scanner to clear the code.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.