Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means there's a problem with a sensor that helps control the engine's rocker arms on one side of the engine. It's not getting the right signals.
The P267C code indicates that the engine control module (ECM) has detected a low voltage signal from the rocker arm actuator position sensor on bank 2.
The rocker arm actuator position sensor monitors the position of the rocker arms, which are part of the valve train in the engine. This sensor helps the ECM control the timing and efficiency of the engine. When the signal from this sensor is lower than expected, it triggers the P267C code.
• Check Engine Light is on
• Poor engine performance
• Decreased fuel efficiency
• Faulty rocker arm actuator position sensor
• Wiring issues such as shorts or open circuits
• Faulty ECM
ECM: Engine Control Module
Rocker Arm: A component in the engine that helps open and close the valves.
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connectors for damage or corrosion.
• Test the rocker arm actuator position sensor for proper operation.
• Replace the rocker arm actuator position sensor if faulty.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the ECM if necessary.
• OBD-II scanner
• Multimeter
• Basic hand tools
$150 - $400
Moderate
• Honda Accord
• Chevrolet Silverado
• Ford F-150
• Regular maintenance checks
• Ensure proper engine oil levels
• Inspect wiring harnesses periodically
Sensor Issue
• Avoid driving the vehicle until the issue is resolved to prevent further damage.
• Consult with a professional mechanic for accurate diagnosis.
Check with your vehicle manufacturer for specific warranty coverage related to sensors and the ECM.
This code is relatively uncommon and typically associated with specific makes and models that use advanced variable valve timing systems.
Moderate – It's important to address this issue to avoid potential engine damage and maintain performance.
Driving with a malfunctioning sensor can lead to increased emissions and may not comply with local environmental regulations.
• Engine running
• Warm engine temperature
The rocker arm actuator position sensor is located on the cylinder head of bank 2, which is the side of the engine opposite bank 1.
Q: Can I drive with a P267C code?
A: It's not recommended to drive with this code as it can affect engine performance and fuel efficiency.
Q: How do I reset the P267C code?
A: After fixing the issue, you can use an OBD-II scanner to clear the code. If the problem is resolved, it should not return.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.