Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that a part of the car that helps clean the air from the engine didn't finish its cleaning job. It's like when you start washing dishes but don't finish, so some dishes are still dirty.
The particulate matter sensor is responsible for monitoring the soot levels in the exhaust system. If the regeneration process, which cleans the sensor, is not completed, this code is triggered.
The P24D1 code indicates that the particulate matter sensor regeneration process was initiated but did not complete successfully. This can occur due to issues with the sensor itself, the regeneration process, or related components like the Diesel Particulate Filter (DPF).
• Check Engine Light is on
• Decreased engine performance
• Increased exhaust smoke
• Faulty particulate matter sensor
• Incomplete regeneration cycle
• Issues with the Diesel Particulate Filter (DPF)
Particulate Matter: Tiny particles in the air, often from exhaust emissions.
Regeneration: A process that cleans the Diesel Particulate Filter by burning off soot.
• Use an OBD-II scanner to confirm the code.
• Inspect the particulate matter sensor and its wiring for damage.
• Check the Diesel Particulate Filter for blockages.
• Replace the particulate matter sensor if faulty.
• Ensure the regeneration cycle completes successfully.
• Clean or replace the Diesel Particulate Filter if necessary.
• OBD-II scanner
• Multimeter
• Wrench set
$200 - $800
Moderate
• Ford F-250
• Chevrolet Silverado
• Ram 2500
• Regularly drive the vehicle at highway speeds to allow for complete regeneration.
• Perform scheduled maintenance on the exhaust system.
• Use high-quality diesel fuel.
Sensor Issue
• Avoid short trips that prevent complete regeneration.
• Monitor fuel quality and avoid contaminants.
Check with the vehicle manufacturer for warranty coverage on emissions-related components.
This code has become more common with the increased use of Diesel Particulate Filters and stricter emissions standards.
Moderate – Addressing this issue is important to maintain engine performance and emissions compliance.
Ignoring emissions-related codes can lead to increased pollution and may fail emissions testing.
• Vehicle must be at operating temperature.
• Ensure the vehicle is in a safe location for testing.
The particulate matter sensor is typically located in the exhaust system near the Diesel Particulate Filter.
Q: What happens if I ignore this code?
A: Ignoring this code can lead to decreased engine performance and increased emissions.
Q: Can I drive with this code?
A: While you can drive with this code, it's best to address it soon to avoid further issues.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.