Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer has detected a problem with a sensor that helps control the exhaust gas recirculation (EGR) system. It's like a thermometer that isn't working right, so the car doesn't know if it's too hot or too cold.
The EGR cooler bypass position sensor monitors the position of the EGR cooler bypass valve. If the sensor's readings are outside the expected range, this code is triggered.
The P2498 code is set when the Powertrain Control Module (PCM) detects a range or performance problem with the EGR cooler bypass position sensor on bank 2. This sensor helps manage the flow of exhaust gases through the EGR cooler to optimize engine efficiency and emissions. Bank 2 refers to the side of the engine opposite to bank 1, which contains cylinder 1.
• Check Engine Light is on
• Reduced engine performance
• Increased emissions
• Faulty EGR cooler bypass position sensor
• Wiring issues or poor electrical connections
• Malfunctioning EGR cooler bypass valve
EGR: Exhaust Gas Recirculation
PCM: Powertrain Control Module
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connections to the EGR cooler bypass position sensor.
• Test the EGR cooler bypass position sensor for proper operation.
• Replace the EGR cooler bypass position sensor if faulty.
• Repair or replace damaged wiring or connectors.
• Replace the EGR cooler bypass valve if it's malfunctioning.
• OBD-II scanner
• Multimeter
• Basic hand tools
$150 - $400
Moderate
• Ford F-250
• Chevrolet Silverado
• Ram 1500
• Regular maintenance of the EGR system
• Timely replacement of faulty sensors
• Keep electrical connections clean and secure
Sensor Issue
• If the Check Engine Light is on, have the vehicle inspected as soon as possible.
• Avoid heavy engine loads until the issue is resolved.
Check with your vehicle manufacturer to see if the EGR system components are covered under warranty.
The P2498 code has been associated with issues in vehicles with complex EGR systems, especially in diesel engines.
Moderate – This issue can lead to increased emissions and reduced engine performance.
Driving with a malfunctioning EGR system can increase emissions and may not comply with local emissions regulations.
• Engine at operating temperature
• Vehicle on a flat surface
The EGR cooler bypass position sensor is typically located near the EGR cooler on the engine, on the side corresponding to bank 2.
Q: Can I drive with a P2498 code?
A: It's possible to drive short distances, but it's not recommended as it can lead to increased emissions and reduced performance.
Q: How do I clear a P2498 code?
A: After repairs, use an OBD-II scanner to clear the code. If the issue is resolved, the code should not return.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.