Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the computer in your car is getting a signal from the camshaft that is too high. Think of it like a light bulb that's too bright - the signal is stronger than it should be.
The P23EE code indicates that the signal from the camshaft position sensor B on bank 1 is higher than expected by the engine control module (ECM).
The camshaft position sensor monitors the position of the camshaft and sends this information to the engine control module (ECM). If the ECM detects a signal from camshaft position sensor B on bank 1 that is higher than the expected range, it triggers the P23EE code.
• Check Engine Light illuminated
• Engine may run rough
• Poor fuel economy
• Faulty camshaft position sensor
• Wiring issues such as short circuits or open circuits
• Faulty ECM
Camshaft: A shaft in the engine that controls the opening and closing of the engine's valves.
ECM: Engine Control Module, the computer that controls the engine's functions.
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connectors related to the camshaft position sensor.
• Test the camshaft position sensor for proper operation.
• Replace the camshaft position sensor if faulty.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the ECM if necessary.
• OBD-II scanner
• Multimeter
• Basic hand tools
$150 - $400
Moderate
• Toyota Camry
• Honda Accord
• Ford F-150
• Regular maintenance checks
• Ensure proper engine oil levels
• Inspect wiring for damage regularly
Sensor Issue
• Do not ignore the Check Engine Light.
• Have the vehicle inspected by a professional.
• Avoid driving long distances until the issue is resolved.
Check if the vehicle's powertrain warranty covers sensor replacement.
This code is relatively uncommon and typically associated with sensor or wiring issues.
Moderate – It is advisable to address this issue soon to avoid potential engine performance problems.
Ignoring a Check Engine Light can lead to more severe engine problems and may affect vehicle emissions.
• Engine at operating temperature
• Vehicle stationary
The camshaft position sensor is typically located near the top of the engine, close to the camshaft.
Q: Can I drive with a P23EE code?
A: It's not recommended to drive for long distances with this code, as it can affect engine performance.
Q: How do I reset the Check Engine Light after fixing the issue?
A: Use an OBD-II scanner to clear the code, or disconnect the battery for a few minutes.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.