Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer has detected a problem with a sensor that helps control the amount of gases going back into the engine. It's like a sensor telling you that something is not working right, and it needs to be checked.
The P2382 code indicates that the voltage signal from the Exhaust Gas Recirculation (EGR) Sensor D is lower than expected by the engine control module (ECM).
The EGR system helps reduce emissions by recirculating a portion of the exhaust gases back into the engine cylinders. The EGR Sensor D monitors the position or flow of the EGR valve. A 'Circuit Low' condition means the sensor is reporting a lower voltage than the ECM expects, possibly indicating a wiring issue, a faulty sensor, or a problem with the EGR valve itself.
• Check Engine Light illuminated
• Poor engine performance
• Increased emissions
• Rough idling or stalling
• Reduced fuel efficiency
• Faulty EGR Sensor D
• Wiring issues such as shorts or open circuits
• Faulty EGR valve
• Poor electrical connection at the sensor
• Faulty ECM
EGR: Exhaust Gas Recirculation
ECM: Engine Control Module
OBD-II: On-Board Diagnostics, second generation
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connectors for damage.
• Test the EGR Sensor D for proper operation.
• Check the EGR valve for proper function.
• Verify the ECM is operating correctly.
• Repair or replace damaged wiring or connectors.
• Replace the faulty EGR Sensor D.
• Replace or clean the EGR valve.
• Ensure proper connection to the ECM.
• Reprogram or replace the ECM if necessary.
• OBD-II scanner
• Multimeter
• Wrench set
• Screwdriver set
• Replacement parts as needed
$150 - $500
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regular maintenance checks
• Ensure clean EGR passages
• Use quality fuel to reduce deposits
Sensor Issue
• Have the vehicle inspected by a professional.
• Avoid driving long distances until fixed.
• Monitor for any changes in vehicle performance.
Check your vehicle's warranty coverage for emissions-related components.
The P2382 code has been associated with EGR system issues in vehicles, often due to sensor or wiring faults.
Moderate – Address the issue soon to avoid potential engine performance problems.
Driving with a malfunctioning EGR system can increase emissions and may not comply with emissions regulations.
• Engine at operating temperature
• Vehicle at idle and under load conditions
The EGR sensor is typically located near the EGR valve on the engine.
Q: Can I drive with a P2382 code?
A: It's not recommended to drive for long periods with this code, as it can lead to increased emissions and engine performance issues.
Q: How do I reset the P2382 code?
A: After repairs, use an OBD-II scanner to clear the code. If the issue is fixed, the code should not return.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.