Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means there's a problem with the car's system that controls how hot air from the engine is used. It's like when a valve in a water pipe is stuck and can't control the flow properly.
The P237E code is triggered when the Engine Control Module (ECM) detects a high voltage signal from the exhaust bypass valve control circuit. This indicates that the circuit is not operating within the expected parameters.
The Exhaust Heat Exchanger Exhaust Bypass Valve A is responsible for redirecting exhaust gases to control the temperature and efficiency of the engine. A high circuit signal suggests that there may be an issue with the wiring, the valve itself, or the ECM interpreting the signal incorrectly.
• Check engine light on
• Reduced engine performance
• Poor fuel efficiency
• Faulty exhaust bypass valve
• Wiring issues such as a short circuit
• Defective ECM
ECM: Engine Control Module
OBD-II: On-Board Diagnostics, second generation
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connections to the exhaust bypass valve.
• Test the exhaust bypass valve for proper operation.
• Repair or replace damaged wiring.
• Replace the exhaust bypass valve if faulty.
• Reprogram or replace the ECM if necessary.
• OBD-II scanner
• Multimeter
• Wrench set
$150 - $500
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regular maintenance checks
• Ensure proper wiring connections
• Use quality fuel to avoid exhaust system issues
Sensor Issue
• Have the vehicle inspected by a professional.
• Avoid driving the vehicle extensively until repaired.
Check with your vehicle manufacturer for warranty coverage on emissions-related components.
This code has been increasingly common in vehicles with advanced exhaust systems designed to meet strict emissions standards.
Moderate – It is advisable to address this issue soon to avoid potential engine performance problems.
Driving with a malfunctioning exhaust system may not only affect vehicle performance but also violate emissions regulations.
• Engine at operating temperature
• Vehicle in a safe and stationary position
The exhaust bypass valve is typically located near the exhaust manifold or turbocharger system.
Q: Can I drive with a P237E code?
A: It's not recommended to drive extensively with this code, as it can lead to reduced engine performance and efficiency.
Q: How do I reset the check engine light after fixing the issue?
A: Use an OBD-II scanner to clear the code after repairs are completed.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.