Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer is having trouble reading the pressure inside cylinder number 10 because the sensor might be broken or the wires are not connected well.
The P2352 code is triggered when the Engine Control Module (ECM) detects a problem with the pressure sensor circuit for cylinder 10. This could be due to a faulty sensor or wiring issues.
The P2352 code indicates that there is a malfunction in the pressure sensor circuit for cylinder 10. This sensor is responsible for measuring the pressure within the cylinder to help the ECM optimize engine performance. A fault in this circuit can lead to incorrect pressure readings, affecting engine efficiency and performance.
• Check Engine Light is on
• Poor engine performance
• Increased fuel consumption
• Faulty pressure sensor
• Damaged wiring or connectors
• ECM malfunction
ECM: Engine Control Module, the computer that controls engine functions.
OBD-II: On-Board Diagnostics, a standardized system for vehicle diagnostics.
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connectors for cylinder 10 pressure sensor.
• Test the pressure sensor for proper operation.
• Replace the faulty pressure sensor.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the ECM if necessary.
• OBD-II scanner
• Multimeter
• Socket set
$150 - $400
Moderate
• Ford F-150
• Chevrolet Silverado
• Dodge Ram
• Regularly inspect engine wiring.
• Ensure sensors are clean and functioning.
• Perform routine maintenance checks.
Sensor Issue
• Do not ignore the Check Engine Light.
• Have the vehicle inspected by a professional.
• Avoid driving the vehicle excessively until repaired.
Check with your vehicle manufacturer for warranty coverage on engine sensors.
This code has been associated with sensor failures in certain truck models, often due to harsh operating conditions.
Moderate – It should be addressed soon to prevent further engine issues.
Driving with this code may lead to decreased engine performance and increased emissions.
• Engine at operating temperature
• Vehicle parked on a level surface
The pressure sensor for cylinder 10 is located on the engine block, typically near the cylinder head.
Q: Can I drive with a P2352 code?
A: It's not recommended as it can lead to further engine damage and reduced performance.
Q: How do I reset the P2352 code?
A: After repairs, use an OBD-II scanner to clear the code from the ECM.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.