Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This means that the car's computer detected a problem with the electrical signal going to one of the ignition coils. It's like if a light bulb isn't getting the right amount of power to turn on.
The engine control module (ECM) has detected a high voltage condition in the primary control circuit of the ignition coil labeled 'G'.
The P2319 code is triggered when the ECM detects a voltage level that is higher than expected in the primary control circuit for ignition coil G. This could be due to a short circuit, faulty ignition coil, or issues with the wiring or connectors.
• Check Engine Light is on
• Engine misfires
• Poor engine performance
• Faulty ignition coil G
• Short circuit in the ignition coil wiring
• Poor electrical connection in the ignition coil circuit
ECM: Engine Control Module
OBD-II: On-Board Diagnostics II
• Use an OBD-II scanner to confirm the code.
• Inspect the ignition coil G and its wiring for damage.
• Check for poor connections or corrosion in the ignition coil circuit.
• Replace the faulty ignition coil.
• Repair or replace damaged wiring.
• Clean and secure electrical connections.
• OBD-II scanner
• Multimeter
• Basic hand tools
$100 - $300
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regularly inspect ignition coils and wiring.
• Avoid exposure of ignition components to moisture.
• Use high-quality replacement parts.
Engine Performance
• Avoid driving the vehicle until repaired to prevent further damage.
• Consult a professional mechanic for accurate diagnosis.
Check with your vehicle manufacturer for warranty coverage on ignition components.
This code is commonly associated with ignition coil failures and has been noted in vehicles with high mileage or poor maintenance.
Moderate – Addressing this issue promptly can prevent further engine damage.
Driving with a misfiring engine can lead to increased emissions and potential damage to the catalytic converter.
• Engine running
• Vehicle at operating temperature
The ignition coil G is located on the engine, typically near the spark plugs.
Q: Can I drive with a P2319 code?
A: It's not recommended to drive with this code as it can cause engine damage.
Q: How can I reset the Check Engine Light?
A: After repairs, use an OBD-II scanner to clear the code and reset the light.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.
Fitment Required · Vehicle-fitment part
Commonly relevant for misfire, ignition-efficiency, and some drivability-related repairs.
Misfire and ignition-related faults commonly involve spark plugs as part of the repair path.
Check the correct plug type, gap, and engine application for your vehicle.
View options on Amazon
Fitment Required · Vehicle-fitment part
Relevant when the fault points toward ignition-coil performance or cylinder-specific ignition issues.
Some ignition faults involve coil performance or cylinder-specific coil problems.
Match the coil to your engine and confirm the failed component before ordering.
View options on AmazonThese parts may be related to this fault category, but a code by itself does not confirm exact fitment or guarantee that replacing a part will solve the problem.