Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer has detected too much water in the fuel. It's like when you accidentally put water in your juice, and it doesn't taste right. The car doesn't like water in its fuel because it can make the engine run badly.
The P2267 code is triggered when the engine control module (ECM) detects a high voltage signal from the water in fuel sensor, indicating excessive water content in the fuel system.
The water in fuel sensor is responsible for detecting the presence of water in the fuel system. A 'circuit high' condition indicates that the sensor is sending a voltage signal higher than expected, which usually means there is too much water in the fuel or an electrical issue with the sensor circuit.
• Check Engine Light illuminated
• Poor engine performance
• Engine stalling or hesitation
• Excessive water in the fuel tank
• Faulty water in fuel sensor
• Damaged or corroded sensor wiring or connectors
ECM: Engine Control Module
OBD-II: On-Board Diagnostics, Second Generation
• Check for water in the fuel tank and drain if necessary.
• Inspect the water in fuel sensor for damage or corrosion.
• Test the sensor wiring and connectors for continuity and proper voltage.
• Drain and clean the fuel tank to remove water.
• Replace the faulty water in fuel sensor.
• Repair or replace damaged wiring or connectors.
• OBD-II scanner
• Multimeter
• Fuel tank draining equipment
$150 - $400
Moderate
• Ford F-250
• Chevrolet Silverado
• Dodge Ram
• Regularly check and drain water from the fuel filter.
• Use high-quality fuel from reputable sources.
• Keep the fuel tank full to prevent condensation.
Sensor Issue
• Avoid driving with this code for extended periods to prevent engine damage.
• Have a professional mechanic inspect and repair the issue promptly.
Repairs may be covered under the vehicle's powertrain warranty if the vehicle is still under warranty.
This code has been more common in diesel engines due to the nature of diesel fuel systems and their susceptibility to water contamination.
Moderate – Address this issue soon to prevent potential engine damage.
Driving with excessive water in the fuel can lead to engine damage and increased emissions, which may not comply with emissions regulations.
• Engine running
• Fuel system pressurized
The water in fuel sensor is typically located near the fuel filter or in the fuel tank.
Q: Can I drive with a P2267 code?
A: It's not recommended to drive with this code for long periods as it can lead to engine damage.
Q: How does water get into the fuel?
A: Water can enter the fuel system through condensation or contaminated fuel sources.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.