Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer is having trouble getting a steady signal from a sensor that measures how hot the exhaust gases are on one side of the engine.
The P2083 code is triggered when the Engine Control Module (ECM) detects an inconsistent or intermittent signal from the exhaust gas temperature sensor located on bank 2, sensor 1.
The exhaust gas temperature sensor measures the temperature of the exhaust gases leaving the engine. It helps the ECM manage emissions and engine performance. When the signal from this sensor is intermittent, it suggests a problem with the sensor or its circuit, which can affect engine efficiency and emissions control.
• Check Engine Light illuminated
• Possible decrease in fuel efficiency
• Potential increase in emissions
• Faulty exhaust gas temperature sensor
• Wiring issues such as frayed or damaged wires
• Poor electrical connections
ECM: Engine Control Module
OBD-II: On-Board Diagnostics II
• Use an OBD-II scanner to confirm the code.
• Inspect the exhaust gas temperature sensor and its wiring for damage.
• Check for loose or corroded electrical connections.
• Replace the faulty exhaust gas temperature sensor.
• Repair or replace damaged wiring.
• Ensure all electrical connections are secure and clean.
• OBD-II scanner
• Multimeter
• Basic hand tools
$150 - $300
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regular inspection of sensor connections and wiring.
• Routine maintenance and check-ups.
• Use of quality parts during repairs.
Sensor Issue
• Have the issue diagnosed and repaired promptly to avoid further damage.
• Consider regular maintenance checks to prevent similar issues.
Sensor-related repairs may be covered under the vehicle's emissions warranty.
This code has been associated with sensor failures and wiring issues in vehicles with higher mileage.
Moderate – While not immediately critical, it should be addressed to prevent potential engine performance issues.
Ignoring this code may lead to increased emissions, which could violate environmental regulations.
• Engine running at normal operating temperature
• Vehicle driven under normal conditions
The sensor is located in the exhaust system, typically near the exhaust manifold on bank 2 of the engine.
Q: What does an exhaust gas temperature sensor do?
A: It measures the temperature of the exhaust gases to help the engine control module manage emissions and engine performance.
Q: Can I drive with a P2083 code?
A: While the vehicle may still be drivable, it's best to address the issue to avoid potential engine performance problems.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.