Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that there is a problem with a sensor in the engine that helps control how air gets into the engine. It's like when a door in a house doesn't open and close properly. This can make the car run poorly.
The P207E code is triggered when the Engine Control Module (ECM) detects an intermittent issue with the circuit of the Intake Manifold Tuning (IMT) Valve Position Sensor on Bank 2.
The IMT valve is responsible for optimizing the air flow into the engine cylinders by adjusting the intake manifold's geometry. The position sensor monitors the valve's position and sends this information to the ECM. If the sensor's signal is erratic or inconsistent, the ECM will set the P207E code.
• Check Engine Light is on
• Reduced engine performance
• Poor fuel economy
• Faulty IMT valve position sensor
• Wiring issues or poor connections in the sensor circuit
• Malfunctioning ECM
ECM: Engine Control Module
IMT: Intake Manifold Tuning
• Scan the vehicle for codes and freeze frame data.
• Inspect the wiring and connectors for the IMT valve position sensor.
• Test the IMT valve position sensor for proper operation.
• Replace the faulty IMT valve position sensor.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the ECM if necessary.
• OBD-II scanner
• Multimeter
• Basic hand tools
$150 - $400
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regular maintenance checks
• Ensure proper electrical connections
• Use quality fuel
Sensor Issue
• Have the vehicle inspected by a professional.
• Avoid heavy acceleration until repaired.
Check with the vehicle manufacturer for warranty coverage on emission-related components.
This code has been more common in vehicles with higher mileage and in those that have not been regularly maintained.
Moderate – It should be addressed soon to prevent potential engine performance issues.
Driving with this code may lead to increased emissions and reduced fuel efficiency. It is advisable to have it repaired to meet emission standards.
• Engine at operating temperature
• Vehicle in closed-loop mode
The IMT valve position sensor is typically located on the intake manifold of the engine, on the side corresponding to Bank 2.
Q: What happens if I ignore the P207E code?
A: Ignoring this code can lead to poor engine performance and reduced fuel efficiency over time.
Q: Can I drive my car with the P207E code?
A: While the car may still be drivable, it's best to have it checked soon to avoid further issues.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.
Fitment Required · Vehicle-fitment part
Relevant for airflow, fuel-trim, and intake-metering faults after confirming the sensor is actually at fault.
Airflow and fuel-trim codes can involve the mass air flow sensor after proper diagnosis.
Verify the sensor design and fitment for your exact vehicle.
View options on AmazonThese parts may be related to this fault category, but a code by itself does not confirm exact fitment or guarantee that replacing a part will solve the problem.