Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
The car's computer detected that the voltage from a sensor in the battery system is higher than it should be.
The Battery Energy Control Module monitors the voltage levels of the battery. If the voltage reading from Sensor 'B' is too high, it triggers this code.
This code indicates that the Battery Energy Control Module (BECM) has detected that the voltage from the voltage sensor 'B' in circuit 'B' is higher than the expected range. This could be due to a fault in the sensor, wiring issues, or a problem with the BECM itself.
• Check Engine Light is on
• Possible battery charging issues
• Reduced vehicle performance
• Faulty voltage sensor
• Wiring issues or poor connections
• Battery Energy Control Module malfunction
Battery Energy Control Module: A component that manages the battery's energy and monitors its status.
Voltage Sensor: A device that measures the voltage level in a circuit.
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connections to Sensor 'B'.
• Test the voltage sensor for proper operation.
• Replace the faulty voltage sensor.
• Repair or replace damaged wiring or connectors.
• Replace the Battery Energy Control Module if necessary.
• OBD-II scanner
• Multimeter
• Basic hand tools
$150 - $500
Moderate
• Chevrolet Volt
• Cadillac ELR
• Chevrolet Malibu Hybrid
• Regularly check battery connections.
• Ensure sensors are clean and free from corrosion.
• Perform routine maintenance on the battery system.
Sensor Issue
• Have the vehicle inspected by a professional.
• Avoid long trips until the issue is resolved.
Check with the vehicle manufacturer for warranty coverage on battery components.
This code is often associated with hybrid or electric vehicles where battery management is critical.
Moderate – Should be addressed soon to prevent further issues.
Driving with this code may affect vehicle performance and efficiency. Address promptly to ensure safety.
• Vehicle in 'On' position
• Battery system fully connected
The Battery Energy Control Module is typically located near the vehicle's battery pack.
Q: Can I drive with a P1EE3 code?
A: It's possible, but not recommended as it may lead to further issues.
Q: How do I clear a P1EE3 code?
A: Fix the underlying issue and use an OBD-II scanner to clear the code.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.