Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
Your car has a special part that helps it run on electricity. This part has three wires, and one of them isn't working right now.
The code P1E0C indicates an issue with the electrical circuit in the inverter that controls one of the phases (Phase U) of the drive motor 'B'. This could mean there's an open circuit or a disconnection in the wiring.
The P1E0C code is triggered when the Powertrain Control Module (PCM) detects an open or faulty circuit in the Phase U of the Drive Motor 'B' inverter. This can prevent the motor from receiving the correct electrical signals needed to operate efficiently.
• Reduced vehicle performance
• Warning light on dashboard
• Unusual noises from the motor
• Faulty inverter circuit
• Damaged wiring or connectors
• Failed drive motor inverter
Inverter: A device that converts direct current (DC) to alternating current (AC).
Phase U: One of the three phases in a three-phase electrical system used in electric motors.
• Inspect the wiring and connectors for damage.
• Check the inverter for any signs of failure.
• Use a multimeter to test the continuity of the Phase U circuit.
• Repair or replace damaged wiring.
• Replace faulty connectors.
• Replace the drive motor inverter if necessary.
• Multimeter
• Screwdriver set
• Wiring repair kit
$200 - $1000
Difficult
• Chevrolet Volt
• Toyota Prius
• Nissan Leaf
• Regular maintenance checks
• Avoid driving through deep water
• Ensure proper cooling of electrical components
Electrical Circuit Issue
• Avoid driving the vehicle until repaired.
• Consult a professional mechanic for accurate diagnosis.
Check with your vehicle manufacturer for warranty coverage on hybrid/electric components.
This code has been more frequently reported in hybrid and electric vehicles due to their reliance on complex electrical systems.
High – Driving with this issue can lead to further damage or reduced vehicle performance.
Operating a vehicle with a known electrical fault can lead to safety hazards. It is advised to address this issue promptly.
• Vehicle in 'ON' position
• Battery fully charged
The drive motor inverter is typically located near the electric motor, often under the hood or in the vehicle's trunk area.
Q: Can I drive my car with code P1E0C?
A: It's not recommended to drive the vehicle with this code active, as it can lead to further damage.
Q: What does the inverter do?
A: The inverter converts the battery's DC power to AC power to drive the electric motor.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.