Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
The car's computer is confused because a sensor that checks the pressure in the heat pump is giving strange readings.
The vehicle's control module has detected an implausible reading from the heat pump pressure/temperature sensor 'B'. This means the data doesn't match expected values.
The heat pump pressure/temperature sensor 'B' is responsible for monitoring the pressure and temperature within the heat pump system. An implausible signal indicates that the sensor is providing data that is outside the expected range, which could be due to a sensor malfunction, wiring issues, or a problem within the heat pump system itself.
• Check Engine Light is on
• Reduced heating or cooling efficiency
• Unusual noises from the heat pump system
• Faulty heat pump pressure/temperature sensor 'B'
• Wiring issues or poor electrical connections
• Malfunctioning heat pump system
OBD-II: On-Board Diagnostics, a standardized system for vehicle self-diagnosis and reporting
Heat Pump: A system that transfers heat from one place to another, used in vehicles for heating and cooling
• Use an OBD-II scanner to confirm the code
• Inspect the wiring and connections to the sensor
• Test the sensor for proper operation
• Replace the faulty sensor
• Repair or replace damaged wiring
• Service the heat pump system
• OBD-II scanner
• Multimeter
• Basic hand tools
$100 - $300
Moderate
• Vehicle 1
• Vehicle 2
• Vehicle 3
• Regular maintenance of the heat pump system
• Routine checks of electrical connections
• Promptly addressing any unusual system behavior
Sensor Issue
• Do not ignore the Check Engine Light
• Seek professional diagnosis if unsure
• Keep up with regular vehicle maintenance
Check if the sensor is covered under the vehicle's warranty as it may vary by manufacturer.
This code has been associated with issues in vehicles equipped with advanced climate control systems.
Moderate – It should be addressed soon to avoid further issues with the heating and cooling system.
Driving with a malfunctioning heat pump system can lead to discomfort and potential safety issues, especially in extreme weather conditions.
• Engine running
• Heat pump system activated
The heat pump pressure/temperature sensor 'B' is typically located near the heat pump unit, often in the engine bay or under the vehicle.
Q: Can I drive with this code?
A: It is possible, but not recommended as it may affect the vehicle's heating and cooling performance.
Q: How can I reset the code?
A: You can reset the code using an OBD-II scanner, but if the issue is not fixed, the code will likely return.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.