Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that there's a problem with the car's charging system. It's like when your phone charger is plugged in but not working because the cable is loose.
The P1C93 code is triggered when the vehicle's computer detects a low voltage or no signal from the charge enable circuit of the Loading Interface Module.
The Loading Interface Module is responsible for managing the charging process of the vehicle's battery. The Charge Enable Signal Circuit is part of this system, and it sends a signal to allow charging to occur. A 'Circuit Low' condition indicates that the signal is weaker than expected or absent, which can prevent the battery from charging properly.
• Battery not charging
• Warning light on the dashboard
• Reduced vehicle performance
• Faulty Loading Interface Module
• Damaged or corroded wiring/connectors
• Faulty battery or charging system components
Loading Interface Module: A component that manages the charging process of the vehicle's battery.
Circuit Low: A condition where the expected electrical signal is weaker than normal or absent.
• Check for any visible damage or corrosion in the wiring and connectors.
• Test the Loading Interface Module for proper operation.
• Inspect the battery and charging system components for faults.
• Repair or replace damaged wiring/connectors.
• Replace the Loading Interface Module if faulty.
• Service or replace battery/charging system components as needed.
• Multimeter
• OBD-II scanner
• Basic hand tools
$150 - $500
Moderate
• Chevrolet Volt
• Nissan Leaf
• Toyota Prius
• Regularly inspect charging cables and connectors for wear.
• Keep the battery and charging system components clean.
• Schedule regular maintenance checks.
Electrical Circuit Issue
• Avoid driving the vehicle until the issue is resolved to prevent battery drain.
• Consult with a certified technician for accurate diagnosis and repair.
Check with your vehicle manufacturer for warranty coverage on electrical components.
This code is relatively uncommon and usually associated with hybrid or electric vehicles.
High – This issue can prevent the vehicle from charging properly, leading to potential breakdown.
Driving with a faulty charging system can lead to unexpected vehicle shutdowns, posing a safety risk.
• Vehicle in 'ON' position
• Battery charging system active
The Loading Interface Module is typically located near the vehicle's battery or within the engine compartment.
Q: Can I drive my car with the P1C93 code?
A: It's not recommended to drive with this code active, as it may lead to battery issues and potential vehicle shutdown.
Q: How can I clear the P1C93 code?
A: The code can be cleared using an OBD-II scanner after the underlying issue is resolved.
Pro · Four-system diagnostics
A handheld scanner aimed at engine, transmission, ABS, and airbag diagnostic work.
Chassis and ABS faults usually need a scanner that can read brake-system data directly.
View on Amazon
Universal · Torque wrench
Useful when reassembly torque matters for wheel, suspension, and under-hood fasteners.
Useful when wheel, hub, or suspension hardware needs correct reassembly torque.
View on Amazon
Universal · Drive-on ramps
Helpful for safer access underneath the vehicle during exhaust, EVAP, and underbody inspection work.
Helpful for safer access during underbody inspection work.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.