Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer detected a problem with the sensor that checks the voltage level of the charger. It's saying the voltage is too high.
The vehicle's control module is receiving a voltage signal from the charge enable voltage sensor that is higher than expected.
The P1C49 code indicates that the Universal Charger Extension Control Module has detected an abnormally high voltage reading from the Charge Enable Voltage Sensor Circuit. This could be due to a malfunctioning sensor, wiring issues, or a problem with the module itself.
• Check engine light is on
• Charging system may not function properly
• Possible reduced vehicle performance
• Faulty charge enable voltage sensor
• Wiring issues or short circuits
• Malfunctioning Universal Charger Extension Control Module
Voltage Sensor: A device that measures the electrical voltage in a circuit.
OBD-II: On-Board Diagnostics, a standardized system for vehicle diagnostics.
• Use an OBD-II scanner to verify the code.
• Inspect the wiring and connectors for damage or corrosion.
• Test the charge enable voltage sensor for proper operation.
• Replace the faulty charge enable voltage sensor.
• Repair or replace damaged wiring or connectors.
• Replace the Universal Charger Extension Control Module if necessary.
• OBD-II scanner
• Multimeter
• Basic hand tools
$150 - $500
Moderate
• Chevrolet Volt
• Nissan Leaf
• Toyota Prius
• Regularly inspect and maintain vehicle wiring.
• Ensure charging systems are functioning correctly.
• Use recommended charging equipment.
Sensor Issue
• Avoid using the vehicle's charging system until repaired.
• Consult with a professional mechanic for accurate diagnosis.
Check with the vehicle manufacturer for warranty coverage on electrical components.
This code has been reported in vehicles with electric or hybrid charging systems, often due to sensor or wiring issues.
Moderate – Addressing this issue promptly can prevent further electrical system problems.
Driving with a malfunctioning charging system can lead to unexpected vehicle shutdowns. Ensure repairs are made promptly.
• Vehicle in park with the ignition on.
• Charging system engaged.
The charge enable voltage sensor is typically located near the vehicle's charging port or within the charging system module.
Q: Can I drive my car with this code?
A: It's not recommended to drive with this code, as it may affect the charging system and vehicle performance.
Q: Is this a common problem?
A: This issue can occur in vehicles with electric or hybrid systems, especially if there are wiring or sensor faults.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.