Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer has detected that the voltage in the electric motor's circuit is too high. It's like when you plug in a device and the voltage is too strong, which can be dangerous.
The P1AEE code indicates that the voltage in the high voltage circuit for Drive Motor 'A' is above the expected range.
The P1AEE code is set when the Powertrain Control Module (PCM) detects that the voltage in the high voltage circuit for Drive Motor 'A' is higher than the manufacturer's specified range. This could be due to a fault in the circuit, a malfunctioning component, or an issue with the battery pack.
• Check Engine Light is on
• Reduced vehicle performance
• Possible warning messages on the dashboard
• Faulty drive motor
• High resistance in the circuit
• Malfunctioning battery pack
PCM: Powertrain Control Module
OBD-II: On-Board Diagnostics, Second Generation
• Use a scan tool to verify the code
• Inspect the high voltage wiring and connectors for damage
• Check the drive motor and battery pack for faults
• Replace or repair damaged wiring or connectors
• Replace the faulty drive motor
• Service or replace the battery pack
• OBD-II scan tool
• Multimeter
• Insulated tools for high voltage systems
$500 - $2000
Difficult
• Chevrolet Volt
• Nissan Leaf
• Toyota Prius
• Regular maintenance of the electric drive system
• Ensure proper insulation of high voltage components
• Avoid overloading the vehicle's electrical system
Electrical Circuit Issue
• Do not drive the vehicle until the issue is resolved
• Consult a professional technician for high voltage systems
Check with the vehicle manufacturer for warranty coverage on hybrid or electric components.
This code is more common in hybrid and electric vehicles due to their complex electrical systems.
High – This issue can affect vehicle performance and safety.
Handling high voltage systems can be dangerous. Only qualified technicians should attempt repairs.
• Vehicle must be in a safe and secure location
• Ensure the vehicle is powered off before inspection
The drive motor and associated high voltage components are typically located near the vehicle's battery pack or under the hood.
Q: Can I drive my car with a P1AEE code?
A: It's not recommended to drive the vehicle as it may have reduced performance and could be unsafe.
Q: Is this code covered under warranty?
A: It depends on your vehicle's warranty policy. Check with your manufacturer or dealer.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.