Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer is getting a signal that the temperature sensor in the transmission is reading too high. It's like when a thermometer says it's way too hot outside.
The Transmission Control Module (TCM) monitors the temperature of the transmission fluid. If the sensor reports a temperature that is higher than expected, the TCM sets the P1710 code.
The P1710 code is triggered when the TCM detects a voltage signal from the temperature sensor that is higher than the normal operating range. This could indicate a fault in the sensor circuit or the sensor itself.
• Check Engine Light is on
• Transmission may overheat
• Poor transmission performance
• Faulty transmission temperature sensor
• Wiring issues such as short circuits or open circuits
• Faulty TCM
TCM: Transmission Control Module
OBD-II: On-Board Diagnostics II
• Use an OBD-II scanner to confirm the code
• Inspect the wiring and connectors for damage
• Test the transmission temperature sensor
• Replace the transmission temperature sensor
• Repair or replace damaged wiring or connectors
• Replace the TCM if necessary
• OBD-II scanner
• Multimeter
• Basic hand tools
$150 - $400
Moderate
• Nissan Altima
• Toyota Camry
• Honda Accord
• Regular transmission fluid checks
• Routine maintenance of transmission system
• Ensure proper cooling of transmission
Sensor Issue
• Avoid driving long distances until the issue is resolved
• Monitor transmission fluid levels regularly
Check with the vehicle manufacturer for specific warranty coverage related to the transmission system.
The P1710 code has been more commonly reported in vehicles with high mileage or inadequate maintenance of the transmission system.
Moderate – Address the issue soon to prevent potential transmission damage.
Ignoring this issue may lead to transmission damage, which can be costly and affect vehicle safety.
• Vehicle at normal operating temperature
• Transmission in normal operating mode
The transmission temperature sensor is typically located within or near the transmission housing.
Q: Can I drive with a P1710 code?
A: It's not recommended to drive for long periods. The transmission may overheat, leading to further damage.
Q: How can I reset the P1710 code?
A: After repairs, you can reset the code with an OBD-II scanner. However, ensure the issue is fixed to prevent the code from returning.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.