Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
The car's computer is saying that the battery is getting too much electricity flowing through it, which can be bad.
The P14CC code is triggered when the vehicle's onboard computer detects that the current flowing through the battery sensor is higher than expected.
The battery sensor monitors the current flowing in and out of the battery. If the sensor detects a current that exceeds the predefined threshold, it sends a signal to the Engine Control Module (ECM), which triggers the P14CC code.
• Check Engine Light is on
• Battery warning light may illuminate
• Possible battery charging issues
• Faulty battery sensor
• Short circuit in the wiring
• Defective alternator
ECM: Engine Control Module, the computer that controls the engine.
OBD-II: On-Board Diagnostics, a standardized system for self-diagnostics in vehicles.
• Use an OBD-II scanner to confirm the P14CC code.
• Inspect the battery sensor and its wiring for damage.
• Test the alternator output and battery voltage.
• Replace the faulty battery sensor.
• Repair or replace damaged wiring.
• Replace the alternator if it is defective.
• OBD-II scanner
• Multimeter
• Wrench set
$100 - $400
Moderate
• Chevrolet Volt
• Chevrolet Malibu
• Buick LaCrosse
• Regularly inspect battery connections.
• Ensure the battery is properly maintained.
• Check the alternator output periodically.
Sensor Issue
• Avoid driving long distances until the issue is resolved.
• Have the vehicle inspected by a professional mechanic.
Check with your vehicle manufacturer for specific warranty coverage on electrical components.
This code has been reported in vehicles with advanced battery management systems, often related to hybrid or electric models.
Moderate – Address the issue soon to prevent potential battery or electrical system damage.
Ignoring this code may lead to battery failure, which can affect vehicle performance and safety.
• Engine running
• Battery under load
The battery sensor is typically located near the battery, often integrated into the battery cable or terminal.
Q: Can I drive with a P14CC code?
A: It's not recommended to drive for long distances with this code active, as it may lead to battery or electrical issues.
Q: How do I clear the P14CC code?
A: After addressing the issue, you can clear the code with an OBD-II scanner. If the problem is fixed, the code should not return.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.