Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
The car's computer is saying that the part that controls the fuel pump is getting too hot.
The Fuel Pump Control Module monitors and controls the operation of the fuel pump. If it gets too hot, it may not work properly.
The P12CC code indicates that the Fuel Pump Control Module 'A' has detected a temperature that exceeds its normal operating range, which can lead to performance issues or failure.
• Check Engine Light is on
• Engine stalling or not starting
• Reduced engine performance
• Faulty Fuel Pump Control Module
• Poor electrical connections
• Overheating due to excessive current draw
Fuel Pump Control Module: A device that controls the operation of the fuel pump.
OBD-II: On-Board Diagnostics, a standardized system for self-diagnostics and reporting in vehicles.
• Use an OBD-II scanner to confirm the code
• Inspect the Fuel Pump Control Module for signs of damage or overheating
• Check electrical connections for corrosion or looseness
• Replace the Fuel Pump Control Module if faulty
• Repair or replace damaged wiring or connectors
• Ensure proper ventilation and cooling for the module
• OBD-II Scanner
• Multimeter
• Basic hand tools
$200 - $600
Moderate
• Chevrolet Silverado
• GMC Sierra
• Cadillac Escalade
• Regular maintenance checks
• Ensure proper cooling system function
• Avoid excessive idling in hot weather
Engine Performance
• Avoid driving long distances until repaired
• Monitor engine temperature gauge closely
Check with the vehicle manufacturer for warranty coverage on the Fuel Pump Control Module.
This code has been associated with overheating issues in vehicles with high mileage or in hot climates.
Moderate – It should be addressed soon to prevent potential engine performance issues.
Driving with this code may lead to engine stalling, which can be dangerous. It is recommended to address the issue promptly.
• Vehicle at operating temperature
• Engine running under load
The Fuel Pump Control Module is typically located near the fuel tank or under the rear seat.
Q: Can I drive with a P12CC code?
A: It's not recommended, as it may lead to engine performance issues or stalling.
Q: How do I reset the P12CC code?
A: You can use an OBD-II scanner to clear the code, but the underlying issue should be fixed first.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.