Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means there's a problem with the sensor that tells the car's computer how much you're pressing the gas pedal. It's like the car can't hear you when you tell it to go faster.
The P1222 code indicates that the voltage signal from the Pedal Position Sensor 2 is lower than expected by the engine control module (ECM).
The Pedal Position Sensor 2 is responsible for sending a voltage signal to the ECM that corresponds to the position of the accelerator pedal. If the ECM detects a voltage lower than the specified range, it triggers the P1222 code.
• Reduced engine performance
• Check Engine Light illuminated
• Unresponsive throttle
• Faulty pedal position sensor
• Wiring issues such as open or short circuits
• Bad electrical connections
ECM: Engine Control Module
OBD-II: On-Board Diagnostics, Second Generation
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connectors for damage.
• Test the pedal position sensor using a multimeter.
• Replace the pedal position sensor if faulty.
• Repair or replace damaged wiring or connectors.
• Clear the code and test drive the vehicle to ensure the repair was successful.
• OBD-II scanner
• Multimeter
• Basic hand tools
$100 - $300
Moderate
• Ford Focus
• Chevrolet Malibu
• Toyota Camry
• Regularly inspect electrical connections.
• Keep the throttle body clean.
• Ensure the pedal assembly is free from obstruction.
Sensor Issue
• Avoid driving at high speeds until the issue is resolved.
• Consult a professional mechanic for accurate diagnosis.
Check if your vehicle's warranty covers sensor issues.
This code has been associated with throttle response issues in various models, often due to sensor wear or wiring problems.
Moderate – It should be addressed soon to avoid further drivability issues.
Driving with this code may reduce vehicle performance and could be unsafe. Address the issue promptly.
• Engine running
• Accelerator pedal pressed
The pedal position sensor is located near the accelerator pedal assembly.
Q: Can I drive with a P1222 code?
A: It's not recommended as it may affect throttle response and vehicle performance.
Q: How do I clear a P1222 code?
A: After repairing the issue, use an OBD-II scanner to clear the code.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.