Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
Your car has a sensor in the fuel tank that checks the pressure. This code means that sensor is saying the pressure is too low.
The fuel tank pressure sensor monitors the pressure inside the fuel tank. If the pressure is lower than expected, this code is triggered.
The P11E6 code indicates that the Powertrain Control Module (PCM) has detected a lower than expected pressure reading from the fuel tank pressure sensor. This sensor is crucial for the vehicle's evaporative emissions system, which helps to prevent fuel vapors from escaping into the atmosphere.
• Check Engine Light is on
• Possible fuel smell
• Reduced fuel efficiency
• Faulty fuel tank pressure sensor
• Damaged or leaking fuel tank
• Faulty wiring or connections to the sensor
PCM: Powertrain Control Module, the computer that controls engine and transmission functions.
OBD-II: On-Board Diagnostics, a standardized system for self-diagnostics in vehicles.
• Use an OBD-II scanner to confirm the code
• Inspect the fuel tank pressure sensor and wiring
• Check for any visible leaks or damage in the fuel tank
• Replace the faulty fuel tank pressure sensor
• Repair or replace damaged wiring
• Fix any leaks in the fuel tank
• OBD-II scanner
• Multimeter
• Wrench set
$100 - $300
Moderate
• Chevrolet Silverado
• Ford F-150
• Toyota Camry
• Regularly inspect the fuel system for leaks
• Ensure proper maintenance of the vehicle's emission system
• Use high-quality fuel to prevent sensor contamination
Sensor Issue
• Do not ignore the Check Engine Light
• Consult with a mechanic if unsure about the repair
• Monitor fuel efficiency for any changes
Check if the vehicle's emission system is still under warranty, as this may cover sensor replacement.
This code has been associated with vehicles that have known issues with their fuel tank pressure sensors, especially in older models.
Moderate – While not immediately dangerous, it should be addressed to prevent further emissions issues.
Driving with a malfunctioning fuel system sensor can lead to increased emissions, which may not comply with local environmental regulations.
• Vehicle is running
• Fuel system is pressurized
The fuel tank pressure sensor is typically located on or near the fuel tank, often integrated into the fuel pump assembly.
Q: Can I drive with the P11E6 code?
A: While you can drive, it's best to fix the issue soon to avoid potential emissions problems.
Q: How do I know if the sensor is faulty?
A: A diagnostic scan and inspection by a professional can confirm if the sensor is faulty.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.
Fitment Required · Vehicle-fitment part
Relevant when EVAP diagnosis points toward purge-flow or purge-control faults.
EVAP diagnosis often includes purge-flow and valve-control faults.
Confirm the failed valve and exact fitment before buying parts.
View options on AmazonThese parts may be related to this fault category, but a code by itself does not confirm exact fitment or guarantee that replacing a part will solve the problem.