Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
The car's computer is getting a signal from a sensor that tells it where a part called the generator is. But the signal is too strong, which means something might be wrong with the sensor or the wires connected to it.
The P0C67 code indicates that the signal from the generator position sensor is higher than expected, which could mean a problem with the sensor or its circuit.
The generator position sensor is responsible for providing the engine control module (ECM) with the position of the generator. A 'high' circuit condition means that the voltage or signal from the sensor is above the expected range, which could be due to a short circuit, faulty sensor, or wiring issues.
• Check Engine Light is on
• Vehicle may not start
• Reduced fuel efficiency
• Faulty generator position sensor
• Short circuit in the sensor wiring
• Faulty ECM
ECM: Engine Control Module, the computer that controls engine functions.
Generator: A device that converts mechanical energy into electrical energy, often referred to as an alternator in vehicles.
• Use an OBD-II scanner to confirm the code
• Inspect the wiring and connectors for damage
• Test the generator position sensor with a multimeter
• Replace the generator position sensor
• Repair or replace damaged wiring
• Replace the ECM if necessary
• OBD-II scanner
• Multimeter
• Basic hand tools
$150 - $400
Moderate
• Toyota Prius
• Chevrolet Volt
• Nissan Leaf
• Regularly inspect wiring for damage
• Ensure connectors are secure
• Perform routine sensor checks
Sensor Issue
• Do not ignore the Check Engine Light
• Have the vehicle inspected by a professional
• Avoid driving the vehicle if performance is affected
Check with the vehicle manufacturer for specific warranty coverage on sensors and electrical components.
This code is commonly associated with hybrid and electric vehicles where generator position sensors play a critical role.
Moderate – Addressing this issue promptly can prevent further damage.
Driving with a malfunctioning generator position sensor can lead to reduced vehicle performance and efficiency. It is advisable to address this issue promptly.
• Vehicle in a safe and stable environment
• Engine off and cooled down
The generator position sensor is typically located near the generator or alternator in the engine compartment.
Q: Can I drive my car with a P0C67 code?
A: It's not recommended to drive for long periods with this code, as it can affect vehicle performance and efficiency.
Q: How do I reset the P0C67 code?
A: After repairing the issue, use an OBD-II scanner to clear the code from the ECM.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.