Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
The car's computer thinks that one of the sensors that tells it where a part of the electric motor is located is sending too high a signal.
This code indicates that the signal from the position sensor for Drive Motor B is higher than expected, suggesting a possible issue with the sensor or its circuit.
The P0C62 code is set when the Powertrain Control Module (PCM) detects an abnormally high voltage signal from the Drive Motor B Position Sensor Circuit B. This sensor helps the PCM understand the position of the motor components to control the electric motor's operation accurately.
• Check Engine Light illuminated
• Reduced vehicle performance
• Electric motor not operating correctly
• Faulty Drive Motor B Position Sensor
• Wiring issues such as open or short circuits
• Faulty PCM or motor control module
PCM: Powertrain Control Module
OBD-II: On-Board Diagnostics II
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connectors for damage or corrosion.
• Test the Drive Motor B Position Sensor for proper operation.
• Repair or replace damaged wiring or connectors.
• Replace the Drive Motor B Position Sensor if faulty.
• Reprogram or replace the PCM if necessary.
• OBD-II Scanner
• Multimeter
• Basic hand tools
$200 - $600
Moderate
• Toyota Prius
• Chevrolet Volt
• Nissan Leaf
• Regularly inspect and maintain wiring and connectors.
• Ensure sensors are clean and free from debris.
• Schedule regular vehicle check-ups.
Sensor Issue
• Address the issue promptly to avoid further damage.
• Consult a professional mechanic if unsure about the repair.
• Avoid driving the vehicle if performance is severely affected.
Check with your vehicle manufacturer for warranty coverage on sensors and electrical components.
This code has been associated with hybrid and electric vehicles as they rely heavily on precise motor control.
Moderate – While the vehicle may still be operable, performance issues could worsen if not addressed.
Ignoring this issue could lead to reduced vehicle performance and potential safety risks.
• Vehicle must be in a safe and stationary position.
• Ensure the vehicle's battery is fully charged.
The Drive Motor B Position Sensor is typically located near the electric motor assembly.
Q: Can I drive with a P0C62 code?
A: It's not recommended as it may affect vehicle performance and could lead to further issues.
Q: How can I reset the P0C62 code?
A: After repairs, use an OBD-II scanner to clear the code, but ensure the issue is fixed first.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.