Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer thinks the battery isn't sending enough power through a specific wire. It's like when your flashlight doesn't work because the batteries aren't connected properly.
The vehicle's control module has detected a low voltage signal from the hybrid or electric vehicle battery voltage sense circuit 'O'.
The P0B83 code indicates that there is a low voltage condition in the battery voltage sense circuit 'O' for a hybrid or electric vehicle. This circuit is responsible for monitoring the voltage of the battery pack, and a low signal could mean a problem with the wiring, connectors, or the battery itself.
• Check Engine Light is on
• Reduced fuel efficiency
• Possible reduced power or performance
• Faulty wiring or connections in the voltage sense circuit
• Defective battery voltage sensor
• Battery pack issues
OBD-II: On-Board Diagnostics, a standardized system for self-diagnostics in vehicles.
Voltage Sensor: A device that measures the voltage present in a circuit.
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connectors in the voltage sense circuit.
• Test the battery voltage sensor for proper operation.
• Repair or replace damaged wiring or connectors.
• Replace the faulty battery voltage sensor.
• Check and repair the battery pack if necessary.
• OBD-II scanner
• Multimeter
• Basic hand tools
$200 - $500
Moderate
• Toyota Prius
• Chevrolet Volt
• Nissan Leaf
• Regularly inspect battery connections.
• Ensure proper maintenance of the battery pack.
• Avoid exposure to extreme temperatures.
Sensor Issue
• Do not ignore the warning light; get it checked soon.
• Avoid long trips until the issue is resolved.
• Consult a professional mechanic for accurate diagnosis.
Warranty coverage may vary; check with your vehicle manufacturer.
This code has been more common as hybrid and electric vehicles become more prevalent.
Moderate – Should be addressed soon to prevent further issues.
Ignoring this code may lead to reduced vehicle performance and efficiency.
• Vehicle in 'Ready' mode
• Battery pack fully charged
The battery voltage sensor is typically located near or within the battery pack.
Q: Can I drive with a P0B83 code?
A: It's possible to drive, but it's not recommended as it may lead to reduced performance and efficiency.
Q: How do I reset the P0B83 code?
A: After repairs, use an OBD-II scanner to clear the code. If the issue persists, the code may return.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.