Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer has detected a problem with one of the sensors that checks the temperature of the battery in a hybrid or electric vehicle. The sensor is saying the temperature is too low, which might not be true, so it needs to be checked.
The P0AC7 code is triggered when the vehicle's Powertrain Control Module (PCM) detects a low voltage signal from the hybrid/EV battery temperature sensor B circuit, indicating a potential fault.
This code indicates that the voltage from the battery temperature sensor B is lower than the expected range. This sensor is responsible for monitoring the temperature of the hybrid/EV battery to ensure it operates within safe limits. A low circuit signal can be caused by a faulty sensor, wiring issues, or a problem with the PCM.
• Check Engine Light illuminated
• Reduced fuel efficiency
• Possible reduced battery performance
• Faulty battery temperature sensor B
• Wiring issues or poor connections in the sensor circuit
• Faulty PCM
PCM: Powertrain Control Module
OBD-II: On-Board Diagnostics II
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connectors for damage or corrosion.
• Test the battery temperature sensor B for proper operation.
• Repair or replace damaged wiring or connectors.
• Replace the faulty battery temperature sensor B.
• Reprogram or replace the PCM if necessary.
• OBD-II scanner
• Multimeter
• Basic hand tools
$150 - $400
Moderate
• Toyota Prius
• Chevrolet Volt
• Nissan Leaf
• Regularly inspect and maintain the battery system.
• Ensure all electrical connections are secure and free of corrosion.
• Perform routine diagnostic checks.
Sensor Issue
• Do not ignore the Check Engine Light; get the vehicle diagnosed promptly.
• Avoid driving aggressively until the issue is resolved.
Check with your vehicle manufacturer as hybrid/EV components may have extended warranties.
This code has been more prevalent with the increase in hybrid and electric vehicles, highlighting the importance of battery management systems.
Moderate – It is important to address this issue to prevent potential battery damage or reduced vehicle performance.
Driving with a malfunctioning battery temperature sensor can lead to decreased performance and potential safety risks.
• Vehicle must be in a safe, stationary position.
• Ensure the battery is at normal operating temperature.
The battery temperature sensor B is typically located within the battery pack or near the battery module in hybrid/EV vehicles.
Q: Can I drive my car with this code?
A: It's possible to drive, but it's not recommended as it may lead to reduced performance or battery damage.
Q: How do I reset the Check Engine Light after repairs?
A: Use an OBD-II scanner to clear the code after ensuring the issue is resolved.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.