Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer thinks there's a problem with the switch that helps you change gears up or down. It's like when a light switch in your house isn't working properly.
The P0828 code is triggered when the transmission control module detects a high voltage signal from the up and down shift switch circuit, indicating a potential issue with the circuit or components.
The up and down shift switch is part of the gear shift system that allows the driver to manually change gears in an automatic transmission. A 'circuit high' condition indicates that the voltage level in the circuit is higher than expected, which can be due to a short circuit, faulty switch, or wiring issues.
• Check Engine Light is on
• Inability to manually shift gears
• Transmission stuck in one gear
• Faulty up and down shift switch
• Short circuit in the wiring
• Faulty transmission control module
OBD-II: On-Board Diagnostics, a standardized system in vehicles for self-diagnosing and reporting
Transmission Control Module: A device that controls modern electronic automatic transmissions
• Use an OBD-II scanner to confirm the code
• Inspect the up and down shift switch for damage
• Check the wiring and connections for shorts or corrosion
• Replace the faulty up and down shift switch
• Repair or replace damaged wiring
• Replace the transmission control module if necessary
• OBD-II scanner
• Multimeter
• Screwdriver set
$100 - $500
Moderate
• Toyota Camry
• Honda Accord
• Ford Focus
• Regularly inspect and maintain transmission components
• Avoid aggressive shifting
• Keep the vehicle's electrical system in good condition
Sensor Issue
• Avoid driving the vehicle until the issue is resolved
• Consult a professional mechanic for accurate diagnosis
Check with the vehicle manufacturer for warranty coverage on transmission components.
This code has been associated with manual shift mode issues in vehicles with automatic transmissions.
Moderate – It is advised to address this issue soon to avoid potential transmission damage.
Driving with a malfunctioning transmission can be dangerous and may lead to further vehicle damage.
• Vehicle must be on and in a safe location
• Transmission in manual mode
The up and down shift switch is typically located on or near the gear shift lever.
Q: Can I drive with a P0828 code?
A: It's not recommended to drive with this code as it may lead to transmission issues.
Q: How do I reset a P0828 code?
A: After repairs, use an OBD-II scanner to clear the code. If the issue persists, further diagnosis is needed.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.