Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer thinks a sensor that measures how fast a part inside the transmission is spinning is getting a signal that's too high.
The P07C6 code is triggered when the vehicle's Powertrain Control Module (PCM) detects a signal from the intermediate shaft speed sensor that is higher than the expected range.
The intermediate shaft speed sensor measures the rotational speed of the intermediate shaft in the transmission. A 'Circuit High' condition indicates that the voltage or signal from the sensor is higher than the PCM expects, which could be due to a short circuit, faulty sensor, or wiring issues.
• Check Engine Light is on
• Transmission may not shift properly
• Reduced fuel efficiency
• Vehicle may enter limp mode
• Faulty intermediate shaft speed sensor
• Short circuit in the sensor wiring
• Faulty PCM
• Corroded or damaged connectors
• Electrical interference
PCM: Powertrain Control Module, the computer that controls the engine and transmission.
OBD-II: On-Board Diagnostics, a system that monitors vehicle performance and emissions.
• Use an OBD-II scanner to verify the code.
• Inspect the wiring and connectors for damage or corrosion.
• Test the intermediate shaft speed sensor for proper operation.
• Check for proper voltage and ground at the sensor.
• Inspect the PCM for faults.
• Replace the intermediate shaft speed sensor if faulty.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the PCM if necessary.
• Clear the code and test drive the vehicle to ensure the issue is resolved.
• OBD-II scanner
• Multimeter
• Screwdrivers
• Wrench set
$150 - $400
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regularly inspect and maintain transmission components.
• Ensure electrical connections are secure and free of corrosion.
• Use quality replacement parts when servicing the transmission.
Sensor Issue
• If the Check Engine Light is on, have the vehicle checked as soon as possible.
• Avoid driving the vehicle hard until the issue is resolved.
Check with your vehicle manufacturer, as some powertrain warranties may cover sensor issues.
This code is relatively common in vehicles with electronic transmissions, particularly as they age and components wear.
Moderate – While the vehicle may still be drivable, ignoring the issue can lead to more serious transmission problems.
Driving with a faulty transmission sensor can lead to unsafe driving conditions. Address the issue promptly.
• Vehicle should be at operating temperature.
• Test should be conducted on a flat surface.
The intermediate shaft speed sensor is typically located on the transmission housing.
Q: Can I drive with a P07C6 code?
A: It's possible, but not recommended. Driving with this code can lead to transmission issues.
Q: How can I reset the P07C6 code?
A: You can reset the code using an OBD-II scanner, but it's important to fix the underlying issue first.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.