Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the sensor that checks how hot the transmission fluid is, is giving a reading that's too high. It's like when a thermometer says it's super hot outside, but it might be broken.
The transmission fluid temperature sensor measures the temperature of the transmission fluid. A high circuit code indicates that the sensor is reporting a higher than expected voltage, suggesting a potential issue with the sensor or its wiring.
The P0713 code is triggered when the Powertrain Control Module (PCM) detects an abnormally high voltage from the transmission fluid temperature sensor circuit. This could be due to a sensor fault, wiring issues, or a problem with the PCM itself.
• Check Engine Light is on
• Transmission may shift harshly
• Poor fuel economy
• Transmission may enter limp mode
• Faulty transmission fluid temperature sensor
• Damaged or corroded wiring/connectors
• Open or shorted sensor circuit
• Faulty PCM
PCM: Powertrain Control Module
OBD-II: On-Board Diagnostics II
• Use an OBD-II scanner to confirm the code
• Inspect the transmission fluid temperature sensor and its wiring
• Check for any signs of damage or corrosion
• Test the sensor's resistance and voltage output
• Replace the transmission fluid temperature sensor
• Repair or replace damaged wiring/connectors
• Clear the code and test drive to confirm repair
• OBD-II scanner
• Multimeter
• Basic hand tools
$100 - $300
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regularly check and maintain transmission fluid levels
• Inspect wiring for wear and tear
• Schedule regular vehicle maintenance
Sensor Issue
• Avoid driving aggressively until the issue is resolved
• Schedule a repair appointment promptly
• Monitor for any unusual transmission behavior
Check with your vehicle's manufacturer for warranty coverage on transmission components.
The P0713 code has been a common issue in vehicles with electronic transmission controls, often related to sensor or wiring failures.
Moderate – It should be addressed soon to avoid potential transmission damage.
Driving with a faulty transmission sensor can lead to unsafe driving conditions. Address the issue promptly.
• Vehicle engine at operating temperature
• Transmission fluid at recommended level
The transmission fluid temperature sensor is typically located inside the transmission or on the transmission valve body.
Q: Can I drive with a P0713 code?
A: It's not recommended to drive for long periods with this code, as it may lead to transmission issues.
Q: How do I reset the P0713 code?
A: After repairs, use an OBD-II scanner to clear the code and verify that it doesn't return.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.