Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
Your car has a sensor that helps it know where a part called the camshaft is. This sensor is not working well, and it's making the car confused.
The engine control module (ECM) is detecting a low voltage signal from the camshaft position sensor B on bank 1.
The P0367 code indicates that the ECM has detected a low voltage condition in the camshaft position sensor B circuit for bank 1. This sensor is responsible for providing the ECM with information about the position of the camshaft, which is crucial for proper engine timing and operation.
• Check Engine Light is on
• Engine may run rough or misfire
• Poor acceleration
• Reduced fuel efficiency
• Faulty camshaft position sensor
• Wiring issues such as shorts or open circuits
• Poor electrical connection
• Faulty ECM
ECM: Engine Control Module
OBD-II: On-Board Diagnostics, Second Generation
• Use an OBD-II scanner to verify the code.
• Inspect the wiring and connections to the camshaft position sensor.
• Test the camshaft position sensor with a multimeter.
• Check the ECM for faults.
• Replace the camshaft position sensor.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the ECM if necessary.
• OBD-II scanner
• Multimeter
• Basic hand tools
$150 - $400
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regular maintenance and inspection of sensors
• Ensure proper electrical connections
• Avoid driving through deep water
Sensor Issue
• Avoid heavy acceleration until the issue is resolved.
• Have the vehicle inspected by a professional mechanic.
Check with your vehicle manufacturer; emissions-related components may be covered under warranty.
This code is commonly associated with sensor failures or wiring issues, often seen in vehicles with higher mileage.
Moderate – Should be addressed soon to avoid potential engine performance issues.
Driving with a malfunctioning camshaft position sensor can lead to increased emissions and potential engine damage.
• Engine at operating temperature
• Idle and varying RPM conditions
The camshaft position sensor B is typically located near the camshaft, often on the top or side of the engine.
Q: Can I drive with a P0367 code?
A: It's not recommended to drive for long periods, as it may lead to engine performance issues.
Q: How can I reset the Check Engine Light?
A: After repairs, use an OBD-II scanner to clear the code. If the issue is fixed, the light should stay off.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.
Fitment Required · Vehicle-fitment part
Commonly relevant for misfire, ignition-efficiency, and some drivability-related repairs.
Misfire and ignition-related faults commonly involve spark plugs as part of the repair path.
Check the correct plug type, gap, and engine application for your vehicle.
View options on Amazon
Fitment Required · Vehicle-fitment part
Relevant when the fault points toward ignition-coil performance or cylinder-specific ignition issues.
Some ignition faults involve coil performance or cylinder-specific coil problems.
Match the coil to your engine and confirm the failed component before ordering.
View options on AmazonThese parts may be related to this fault category, but a code by itself does not confirm exact fitment or guarantee that replacing a part will solve the problem.