Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means that the car's computer is getting a signal that says the gas pedal is pushed down less than it should be. It's like when you press a button and it doesn't work right.
The P0222 code indicates that the voltage signal from the throttle/pedal position sensor/switch B is lower than expected by the engine control module (ECM).
The Throttle/Pedal Position Sensor/Switch B is part of the drive-by-wire system. It sends information about the position of the throttle or pedal to the ECM. If the ECM detects a voltage signal lower than the specified range, it triggers the P0222 code.
• Check Engine Light is on
• Poor acceleration
• Engine may stall or hesitate
• Faulty throttle position sensor
• Damaged wiring or connectors
• ECM malfunction
ECM: Engine Control Module
OBD-II: On-Board Diagnostics, Second Generation
• Use an OBD-II scanner to confirm the code.
• Inspect the wiring and connectors for damage.
• Test the throttle position sensor with a multimeter.
• Replace the throttle position sensor if faulty.
• Repair or replace damaged wiring or connectors.
• Reprogram or replace the ECM if necessary.
• OBD-II scanner
• Multimeter
• Screwdriver set
$100 - $300
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regular maintenance checks
• Keep electrical connections clean
• Avoid harsh driving conditions
Sensor Issue
• Do not ignore the Check Engine Light.
• Have the vehicle inspected by a professional if unsure.
• Avoid driving if the car stalls or hesitates frequently.
Check if the throttle position sensor or ECM is covered under the vehicle's warranty.
This code has been reported in vehicles with electronic throttle control systems, especially as they age.
Moderate – It should be addressed soon to avoid potential drivability issues.
Driving with a malfunctioning throttle position sensor can lead to unsafe driving conditions.
• Engine running
• Throttle pedal pressed
The throttle position sensor is usually located on the throttle body or near the accelerator pedal.
Q: Can I drive with a P0222 code?
A: It's not recommended as it can lead to poor engine performance and safety issues.
Q: How do I reset the P0222 code?
A: After repairs, use an OBD-II scanner to clear the code, or disconnect the battery for a few minutes.
High-End · Full-system diagnostics
A full-system bidirectional platform aimed at advanced DIY users and professional diagnostic workflows.
Network faults often require full-system access instead of a generic code reader alone.
View on Amazon
Universal · Digital multimeter
A solid entry-level multimeter for voltage, continuity, resistance, and basic electrical troubleshooting.
Helpful for checking voltage drops, grounds, and basic circuit health when modules are not communicating.
View on Amazon
Universal · Wire connectors and repair kit
Useful when diagnosis points toward damaged wiring, corroded terminals, or connector repairs.
Useful if diagnosis points toward damaged connectors, wiring, or terminal repairs.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.