Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This code means there's a problem with one of the parts inside the car's computer that helps with braking. It's like a switch isn't working right.
The code C108E indicates an electrical issue with the valve coil 'E' circuit inside the Dynamic Stability Control (DSC) module.
The DSC module is responsible for maintaining vehicle stability by controlling the brakes on individual wheels. Code C108E is triggered when the module detects an electrical fault in the valve coil 'E' circuit, which could be due to a short circuit, open circuit, or other electrical issues.
• ABS or DSC warning light on the dashboard
• Loss of stability control functions
• Unusual braking behavior
• Faulty DSC control module
• Damaged wiring or connectors
• Blown fuse related to the DSC system
DSC: Dynamic Stability Control
OBD-II: On-Board Diagnostics, second generation
• Check for any blown fuses related to the DSC system.
• Inspect the wiring and connectors for damage or corrosion.
• Test the DSC control module for proper operation.
• Replace any blown fuses.
• Repair or replace damaged wiring or connectors.
• Replace the DSC control module if it is faulty.
• OBD-II scanner
• Multimeter
• Basic hand tools
$200 - $800
Moderate
• BMW 3 Series
• Ford Focus
• Mazda CX-5
• Regular maintenance of the braking system.
• Inspect electrical connections periodically.
• Avoid driving through deep water that could damage electrical components.
Electrical Issue
• Do not ignore the warning light on the dashboard.
• Have the vehicle inspected by a professional if you experience braking issues.
Check with your vehicle manufacturer for warranty coverage on the DSC module.
This code has been reported in vehicles with high mileage or those exposed to harsh environmental conditions.
Moderate – It's important to address this issue to ensure vehicle safety and stability.
Driving with a faulty DSC system can increase the risk of loss of control during emergency maneuvers.
• Vehicle should be stationary.
• Ignition in the 'on' position.
The DSC control module is typically located under the hood or near the brake master cylinder.
Q: Can I drive with a C108E code?
A: It's not recommended to drive with this code as it affects vehicle stability and safety.
Q: How do I reset the DSC light?
A: After repairs, the DSC light can be reset using an OBD-II scanner.
Pro · Four-system diagnostics
A handheld scanner aimed at engine, transmission, ABS, and airbag diagnostic work.
Chassis and ABS faults usually need a scanner that can read brake-system data directly.
View on Amazon
Universal · Torque wrench
Useful when reassembly torque matters for wheel, suspension, and under-hood fasteners.
Useful when wheel, hub, or suspension hardware needs correct reassembly torque.
View on Amazon
Universal · Drive-on ramps
Helpful for safer access underneath the vehicle during exhaust, EVAP, and underbody inspection work.
Helpful for safer access during underbody inspection work.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.