Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
The car's brake system has a pump that helps make braking easier. This code means that the pump got too hot.
The vacuum pump in the brake system is responsible for providing the necessary vacuum to assist in braking. This code indicates that the pump's temperature has exceeded safe operating limits.
The C1045 code is triggered when the brake system's vacuum pump temperature sensor detects a temperature that exceeds the predetermined threshold. This could be due to excessive use, a malfunctioning pump, or a fault in the temperature sensor itself.
• Brake warning light on the dashboard
• Reduced braking efficiency
• Unusual noise from the brake system
• Faulty vacuum pump
• Blocked or restricted vacuum lines
• Malfunctioning temperature sensor
Vacuum Pump: A device that removes gas molecules from a sealed volume to create a partial vacuum.
Temperature Sensor: A device that measures temperature through an electrical signal.
• Check for any stored codes related to the brake system.
• Inspect the vacuum pump and its connections for damage or wear.
• Test the temperature sensor for proper operation.
• Replace the faulty vacuum pump.
• Clear any blockages in the vacuum lines.
• Replace the temperature sensor if it is malfunctioning.
• OBD-II scanner
• Multimeter
• Vacuum gauge
$150 - $500
Moderate
• Ford F-150
• Chevrolet Silverado
• Toyota Camry
• Regularly inspect brake system components.
• Ensure proper maintenance of vacuum lines.
• Avoid excessive braking to prevent overheating.
Brake System Issue
• Have your brake system checked regularly.
• If the brake warning light comes on, get it inspected immediately.
Brake system components may be covered under the vehicle's powertrain or bumper-to-bumper warranty.
This code has been commonly reported in vehicles with high mileage or those frequently used in stop-and-go traffic conditions.
High – Brake system issues can affect vehicle safety and should be addressed promptly.
Driving with a malfunctioning brake system can be dangerous and may violate safety regulations.
• Vehicle at normal operating temperature
• Brake system under load
The vacuum pump is typically located near the engine or within the engine bay, attached to the brake booster.
Q: Can I drive with a C1045 code?
A: It's not recommended to drive with this code as it indicates a potential brake system issue.
Q: How can I prevent the vacuum pump from overheating?
A: Regular maintenance and avoiding excessive braking can help prevent overheating.
Pro · Four-system diagnostics
A handheld scanner aimed at engine, transmission, ABS, and airbag diagnostic work.
Chassis and ABS faults usually need a scanner that can read brake-system data directly.
View on Amazon
Universal · Torque wrench
Useful when reassembly torque matters for wheel, suspension, and under-hood fasteners.
Useful when wheel, hub, or suspension hardware needs correct reassembly torque.
View on Amazon
Universal · Drive-on ramps
Helpful for safer access underneath the vehicle during exhaust, EVAP, and underbody inspection work.
Helpful for safer access during underbody inspection work.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.