Easy one-page printout for the garage or repair shop
This summary uses the existing diagnostic information shown in full below.
This means the car's computer thinks the brake pressure sensor is getting too much power.
The brake pressure sensor E is sending a signal to the car's computer that is higher than expected, indicating a potential issue with the sensor or its circuit.
OBD-II Code C05A0 indicates that the brake pressure sensor E circuit is reporting a voltage level that is higher than the manufacturer's specified range. This could be due to a short circuit, a faulty sensor, or an issue with the vehicle's wiring.
• ABS warning light on
• Brake system warning light on
• Reduced braking performance
• Faulty brake pressure sensor
• Short circuit in the brake pressure sensor wiring
• Corroded or damaged connectors
OBD-II: On-Board Diagnostics, a standardized system for self-diagnostics and reporting in vehicles.
ABS: Anti-lock Braking System, a safety system that prevents wheel lock-up during braking.
• Use an OBD-II scanner to confirm the code.
• Inspect the brake pressure sensor and its wiring for damage.
• Check the sensor's electrical connections for corrosion or looseness.
• Replace the faulty brake pressure sensor.
• Repair or replace damaged wiring.
• Clean and secure electrical connections.
• OBD-II scanner
• Multimeter
• Basic hand tools
$100 - $300
Moderate
• Chevrolet Silverado
• GMC Sierra
• Ford F-150
• Regularly inspect brake system components.
• Ensure electrical connections are clean and secure.
• Perform routine maintenance checks.
Sensor Issue
• Do not ignore the warning light; have the vehicle inspected promptly.
• Avoid hard braking until the issue is resolved.
Check with your vehicle manufacturer for warranty coverage on brake system components.
This code has been associated with vehicles experiencing sensor failures due to environmental factors such as moisture and road salt.
High – Brake system issues should be addressed immediately to ensure vehicle safety.
Driving with a compromised brake system can lead to accidents. Address this issue promptly.
• Vehicle in a safe, stationary position.
• Engine off and ignition in the 'on' position.
The brake pressure sensor is typically located near the master cylinder or integrated into the ABS module.
Q: Can I drive with this code?
A: It's not recommended to drive with this code active as it may affect braking performance.
Q: How can I reset the code?
A: After repairs, use an OBD-II scanner to clear the code. If the issue persists, the code will return.
Pro · Four-system diagnostics
A handheld scanner aimed at engine, transmission, ABS, and airbag diagnostic work.
Chassis and ABS faults usually need a scanner that can read brake-system data directly.
View on Amazon
Universal · Torque wrench
Useful when reassembly torque matters for wheel, suspension, and under-hood fasteners.
Useful when wheel, hub, or suspension hardware needs correct reassembly torque.
View on Amazon
Universal · Drive-on ramps
Helpful for safer access underneath the vehicle during exhaust, EVAP, and underbody inspection work.
Helpful for safer access during underbody inspection work.
View on AmazonThese are optional diagnostic tools, not guaranteed fixes. As an Amazon Associate I earn from qualifying purchases.